ZN-502 A/S/AS USER MANUAL
Thank you for purchasing our product. Our systems have all been designed and tested to be compatible with the earliest to latest vehicles available throughout the world. Our primary goal was to provide a reliable and stable product. Our secondary goal was to ensure that our systems are easy to install. Our final goal was to provide features that would benefit the user and installer. We are confident that our products will meet and exceed your expectations.
CAUTION! PLEASE READ CAREFULLY This device under provision section 15.21 of FCC Rule Part 15 that changes or modiications not epressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. The user and installer should completely read the User Manual, Installation Manual, and the vehicle’s manual completely before installing and operating this system.
CONTENTS 1. Introduction 1.1 1.2 1.3 1.4 System Contents Remote Control Button Layout LCD Display Introduction Remote Control Button Introduction 6 7 8 9 2. Primary Features 2.1 2.2 2.3 2.4 2.5 2.6 2.7 Door Lock (Arm) Door Unlock (Disarm) Arm / Disarm Status Car Find & Status LCD Screen Status Panic Remote Start 11 11 11 12 12 12 13 2.8 2.9 Trunk Release Valet Mode 14 14 3. Secondary Features 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.
27 1. INTRODUCTION 1.1 1.2 1.3 1.
1.
Wiring Harness Shock Sensor Z-PASS TOUCH Manuals Siren 7
1.2 Remote Button Control Layout Front View Antenna OLCD / UCLCD CAUTION NEVER use the system except for its intended use. This is an electronic system with complex circuitry. Avoid dropping the components or cause any other physical damage as that will void the warranty. Buttons Battery 1.
Button(s) Duration* Description Ⅰ 0.5 sec Arm / Door Lock Ⅱ 0.5 sec Disarm / Door Unlock Ⅲ× 3 Times 0.5 sec Remote Control Hold ON/OFF Ⅳ 0.5 sec Vehicle Status / Car Finder Ⅰ- 2+ sec Panic Ⅲ- 2+ sec Remote Start Ⅳ- 2 sec Trunk Release Ⅱ~ 4 sec Time / Alarm / Remote Start Timer Set Ⅰ+Ⅳ 0.5 sec Remote Control Beep Mute ON/OFF Ⅱ+Ⅲ 0.5 sec Siren Mute ON/OFF Ⅰ+Ⅱ 0.5 sec Aux 1 Ⅲ+Ⅳ 0.5 sec Aux 2 1.
1.
LEGEND: “ - “ means to hold for 2 seconds - press and hold button(s) until 1st beep is heard from the remote control. “ ~ “ means to hold for 4 seconds - press and hold button(s) until 2nd beep are heard from the remote control. Status Z-Pass LED’s Armed Mode Normal Flash Disarmed Mode No Flash Triggered Alarm Fast Flash 2.
2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 Arm (Door Lock) Disarm (Door Unlock) Arm / Disarm Status Car Find & Status LCD Screen Status Panic Remote Start Trunk Release Valet Mode 2.1 Door Lock (Arm) ButtonⅠ 0.5 sec Successful Arm (Door Lock) Remote Control Vehicle & flash. 1 beep will occur. 1 parking light flash & 1 siren chirp Failed Arm (Door Lock) If a door, while chirps will occur immediately.
Successful Disarm (Door Unlock) & will blink until remote start is turned off. 1 beep will occur if the main Remote Control control module communicates with the remote control. 5 beeps will occur after remote start is successful. Vehicle Remote Control Vehicle 1 parking light flash & 1 siren chirp if the main control module communicates with the remote control. 5 parking light flashes & 5 siren chirps after remote start is successful.
the LED on the Antenna Module will indicate the status of the system. If a door is opened and closed, the Triggered Alarm status & & will blink. 2 Remote Control on the Z-Pass will be beeps will occur. cleared. Vehicle 2 x parking light flashes & 2 siren chirps The siren duration can be programmed through the User Programmable Options 2.4 Vehicle Status / Car Finder Button Ⅳ 0.5 sec Remote Control Vehicle & 1 will blink. 1 parking light flash & 1 siren chirp & Remote Control OFF.
Remote Start On Shock Sensor Trigger Option 1 Input Trigger 2.5 Remote Control Hold ButtonⅢ 0.5 sec x 3 Times Pressing Button Ⅲ 3 times for 0.5 second each will put the remote control buttons into “Hold” mode. Any button presses will be ignored. To come out of “Hold” mode, press Button III 3 times for 0.5 second each again. Hold ON Hold OFF 2.6 Panic ButtonⅠ 2+ sec If there is a potential threat, you can alert those around you by using this feature.
If Button Ⅲ is pressed for 2+ seconds while remote start is on, remote start will turn off. The default remote start engine running time is 15 minutes. The time can be changed through the User Programmable Options. CAUTION: Do not use the remote start feature if the vehicle is in an enclosed area. Do not use the remote start feature where laws prevent its usage. Do not turn the key to the Start position or else damage may be done to the starter motor.
Valet mode OFF Valet mode without remote control (Emergency shut off) 1. Insert the key into the key cylinder and turn to the ON position. 2. Within 3 seconds, press the foot brake 6 times. 3. On the 6th press, hold down the foot brake until 1 parking light flash and 1 siren chirp occur. NOTE: This feature can be used to turn off the alarm with the key if the system has been triggered. NOTE: Valet mode can only be turned off via the remote control.
3.SECONDARY FEATURES 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 3.17 Remote Control Beep Mute Siren Mute Passive Lock (Arm) Safety Relock (Rearm) Ignition Lock Cold Start Timer Turbo Timer Option 1 Input Remote Control Registration Remote Start Reservation User Programmable Options Time, Time Alarm, Timer Remote Start Reservation Set Aux 1 Output Aux 2 Output Shock Sensor Option Shock Sensor Sensitivity Adjustment Z-Pass Touch 3.1 Remote Control Beep Mute ButtonsⅠ+ Ⅳ 0.
Siren Mute OFF - Siren ON Remote Control Vehicle & OFF. will blink. will turn 2 parking light flashes & 2 siren chirps 3.3 Passive Arm (Lock) ButtonsⅠ+Ⅱ 4 sec + Brake Pedal To activate or deactivate this function, the Brake Pedal must be held down at the same time while Buttons I + II are pressed for 4 seconds. Once a door is opened and closed and the system is not armed via the remote control, the system will automatically arm and lock the doors.
the armed state and the system is disarmed but a door is not opened, the system will Safety Rearm automatically within 30 seconds. Safety Rearm (Relock) ON Remote Control & stay ON. will blink. will 1 parking light flash & 1 siren chirp Vehicle Safety Rearm (Relock) OFF Remote Control & turn OFF. will blink. will 2 parking light flashes & 2 siren chirps Vehicle 3.
remote start is turned ON, the timer will automatically restart once the engine is turned OFF. The timer can be set through the User Programmable Options. Cold start timer ON Remote Control Vehicle & will blink. will stay ON. 1 parking light flash & 1 siren chirp Cold start timer OFF Remote Control Vehicle & will blink. will turn OFF. 2 parking light flashes & 2 siren chirps 3.
area. Do not idle the vehicle if any laws prohibit this action. Do not idle the vehicle if it is a convertible or open concept type of vehicle. 3.8 Option 1 Input Additional sensors can be added to the system using Option 1 input. No additional programming is required. When the sensor is triggered, the parking lights will flash and the siren will sound. 3.9 Remote Control Registration 1. 2. 3. 4. Insert key and turn the key to ON position (engine is OFF). Press brake pedal 4 times.
remote start reservation modes: automatic and manual. Please note that automatic and manual do not refer to the transmission type. Rather, automatic and manual refer to the type of remote start reservation. 1. Automatic Remote Start Reservation (Default) a. Before turning off the engine, put the transmission into Neutral. Ensure that the parking brake (emergency brake) is engaged. Take foot off of the foot brake. b. Turn the key to the OFF position. The engine should still be running. c.
User Option Button Sequence Options Ⅰ Ⅱ Ⅲ Remote Start Run Time Ⅳ→Ⅰ 15 min 5 min 25 min Diesel Warm Up Time Ⅳ→Ⅱ 30 sec 15 sec 7.5 sec Siren Sound Time Ⅳ→Ⅲ 30 sec 70 sec 100 sec Turbo Timer Run Time Ⅳ→Ⅳ 1 min 2 min 5 min Remote Start Reservation Ⅲ→Ⅳ Automatic Manual Cold Start Timer Ⅲ→Ⅲ 1 hour 2 hours Shock Sensor ON/OFF Ⅲ→Ⅱ ON OFF Temperature Unit Ⅲ →Ⅰ Fahrenheit Celsius 3 hours Default values.
ButtonⅠ : Time Menu (Time → Alarm→ Remote Start Timer) 4. Triggers The following triggers will occur ONLY when the system is armed. Shock Trigger Remote Control Vehicle & will blink. The remote control will beep or vibrate. Parking lights will flash and siren will sound. Door Trigger Remote Control Vehicle & will blink. The remote control will beep or vibrate. Parking lights will flash and siren will sound. Hood Trigger Remote Control Vehicle & will blink. The remote control will beep or vibrate.
ButtonⅡ : Hours setting. WARRANTY CARD Press and/or hold Button II in order to increase the hours value. Button Ⅲ : Minutes setting. Use this warranty card for your records. Please go to Press and/or hold Button III in order to increase the minutes value. Button Ⅳ: Confirmationwww.zenesisalarms.com or rejection. Visit the linkand above for specific and conditions. Press hold Button IV for 2warranty seconds interms order to accept the desired time or press for 0.5 second in order to reject the set time.