Get started.
HANDLEBAR HEADLIGHT Placeholder STOMP BRAKE NECK LEVER TAIL LIGHT LOCKING SLEEVE CHARGING PORT KICKSTAND
Assembly Materials BIRD AIR VEHICLE (FOLDED) HANDLEBAR ASSEMBLY SCREWS ALLEN WRENCH CHARGER AND PLUG x1 x4 x1 x1
Assembly 1 LIFT THE NECK Lift the vertical tube (neck) from the top and move it to an upright position. 2 ROTATE THE NECK INTO PLACE Rotate the lever at the base of the neck up while holding the neck in place. The lever must be completely locked in the upright position.
3 SLIDE THE LOCKING SLEEVE DOWN Slide the locking sleeve down until it clicks into place with the lever. 4 CONNECT THE HANDLEBAR ASSEMBLY Take the handlebar assembly and connect its connector (green) to the Bird Air connector at the top of the neck. Align the connectors using the arrows as visual aids. Once arrows are aligned push them together to connect.
5 SLIDE THE HANDLEBARS INTO PLACE Slide the handlebar assembly down into the neck with the wires inside. The middle part of the handlebars should slope down toward the rear of the vehicle. Push the handle bar down, until it’s fully seated in the neck. 6 INSTALL THE (4) SCREWS Pick up the (4) screws and the Allen wrench. Then, find the (4) screw holes at the top of the neck, near the handlebar assembly. There are two holes each on opposite sides of the neck. Use the Allen wrench to install the (4) screws.
Charging 1 CONNECT THE POWER ADAPTER Once you’ve assembled your Bird Air, it’s time to charge. Use the included power supply and connect it to the charging port. 2 FINISH CHARGING When fully charged, a green light on the power supply indicates the charge is complete. Disconnect the power supply from the charging port before riding. WARNING: Do not attempt to charge if the charging port or power adaptor is wet. WARNING: Only use charger specified by the manufacturer.
Riding 2 secs 1 POWER ON To turn the Bird Air on or off, hold down the Power button for at least 2 seconds at the bottom of the dash display (center console of the handlebar assembly). The vehicle will audibly “beep” when it is powered on or off. Additionally, the dash display will activate. 2 DOWNLOAD THE BIRD APP Download and install the Bird App on your smartphone to gain wireless access to the dash display controls. Follow the in-app instructions to pair with the vehicle.
x1 3 CHECK THE DASH DISPLAY The Bird Air uses a dash display screen to show the speed (miles per hour or kilometers per hour) and charge level. 4 TURN ON THE HEADLIGHT Press the power button once to turn the headlight on and off. The dash display shows the speed mode the Bird Air is in. There are 3 different speed modes: TAKEOFF GLIDE FLY Max speed of 9 mph/15 km/h Max speed of 12-12.
BRAKE THROTTLE STOMP BRAKE 5 STARTING To start a ride, first, make sure to fold in the kickstand. Kick to start the Bird Air by having one foot on the vehicle and one foot on the ground. Push the vehicle with at least two kicks before boarding it to ride. Press the throttle (accelerator) down at the right handlebar to accelerate the scooter. 6 STOPPING Use the brake at the left handlebar to decelerate or stop the vehicle. Additionally, it is possible to use the stomp brake as a brake for the vehicle.
Folding The Bird Air can be folded for convenience. Ensure the Bird Air is powered off before attempting to fold it. 1 SLIDE THE LOCKING SLEEVE UP Take hold of the locking sleeve and slide the sleeve up from the lever. 2 ROTATE THE LEVER DOWN While holding the locking sleeve in place atop the lever, rotate the lever down. 3 FOLD THE NECK DOWN Take hold of the neck and fold it down 90 degrees until the handlebar assembly is just above the stomp brake.
Unfolding Reverse the folding process to unfold the Bird Air. 1 RELEASE THE TAB Push down the stomp brake to free the tab at the base of the handlebar assembly. 2 SET THE NECK AND LEVER Lift the neck 90 degrees to the upright position on the vehicle. Push the lever at the base of the neck up. 3 SLIDE THE LOCKING SLEEVE DOWN Slide the locking sleeve down into the lever, making sure it clicks into place. The lever must be completely locked in the upright position.
Specifications Battery 5.2 Ah (10S2P) Range Up to 15.5 miles Charging Fast charge port App iOS and Android Firmware Over-the-Air updates Connectivity Bluetooth Splash Resistant Chassis IP34 , Motor IP67 , Battery IP67 Lights Front LED, automatic rear LED Braking Throttle and foot Wheels 7.
Cleaning and Storage - Use a soft, wet cloth to wipe the mainframe clean. Hard to remove dirt can be scrubbed with a toothbrush, then cleaned with a soft wet cloth. - Do not wash your Bird Air with alcohol, gasoline, acetone, or other corrosive solvents. These substances may damage the appearance and internal structure of your Bird Air. Do not wash your Bird Air with a power washer or hose.
Questions? We’ve got answers. Visit support.bird.co for help.
Instructions & Safety Guidelines Before each use, conduct a basic safety inspection of the Bird Air, including: (i) trueness of the wheels & condition of tires; (ii) safe operation of all brakes and lights; (iii) good condition of the frame; (iv) sufficient battery charge power; and (v) any sign of damage, unusual or excessive wear, or other open and obvious mechanical problem/maintenance needs.
Instructions & Safety Guidelines • Avoid contact with moving parts. Ensure hands, feet, hair, clothing, and other body parts stay clear of moving parts like the motor or front wheel. • ALWAYS keep both hands on the handlebar when riding.
Federal Communications Commission (FCC) Compliance Statement for USA This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Disclosure for Users in the State of California as required by CA Vehicle Code 407.5 YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. YOU MAY NOT MODIFY OR ALTER THE EXHAUST SYSTEM OF THIS SCOOTER CAUSE IT TO AMPLIFY OR CREATE EXCESSIVE NOISE PER VEHICLE CODE SECTION 21226, OR TO FAIL TO MEET APPLICABLE EMISSION REQUIREMENTS PER VEHICLE CODE 27156.