User's Manual

ManualsBrandsBircher Reglomat ManualsElectronicsMicrowave Motion Detector

Wall mounting Ceiling mounting

When not mounted When already mounted

1) Remove provided screws for installation.

+ ~12-28 V AC

Common

Normally closed

48 V AC / DC

24 W / 55 VA

white

brown

green

yellow

grey

Normally open

- ~12-36 V DC

Side cable exit as shown on the left or

front cable exit as shown below

sensing the future

* The device must only be operated at a protective low voltage with safe electrical insulation. Product repairs must be performed solely by the manufacturer.

* Shut off all power going to the sensor before attempting any wiring procedures.

* Maintain a clean & safe environment when working in public areas.

* Constantly be aware of pedestrian traffic around the door area.

* Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door.

* Always check placement of all wiring and components before powering up to ensure that moving door parts will not catch any wires and cause damage to equipment.

* Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.

Safety instructions

Microwave motion detector for automatic pedestrian doors [ES with direction recognition] Questions? Call us at 800 - 252-1272, 8am - 5pm central standard time.

DO NOT LEAVE ANY PROBLEMS UNRESOLVED - NEVER SACRIFICE SAFETY FOR ANY REASON

Impulse

motion

1. Turn on power and allow detector

to self-tune

2. Stay outside the detection zone

for 5 seconds

Test the size and position of the

sensing eld

Open sensor with a screwdriver

Drill holes using template

Install sensor with provided screws

Connections

Testing of the settings

Summary of content (3 pages)

PAGE 1
Impulse sensing the future motion Microwave motion detector for automatic pedestrian doors [ES with direction recognition] Questions? Call us at 800 - 252-1272, 8am - 5pm central standard time. Safety instructions * The device must only be operated at a protective low voltage with safe electrical insulation. Product repairs must be performed solely by the manufacturer. * Shut off all power going to the sensor before attempting any wiring procedures.
PAGE 2
6 Setting field shape and position Open position / narrow field Setting all other parameters 9 Closed position / wide field Side position / side field 2 1 Function switch OFF* Digital filter off, normal setting, maximum sensitivity. ON Digital filter on, when filtering of vibration and/or reflective surfaces is necessary. Detection will be less sensitive, requiring more motion to activate the Impulse 6 7 4 5 3 On Off min. Function switch Fig. 6.1 7 Fig. 6.2 1 2 3 4 Fig. 6.3 max.
PAGE 3
FCC APPROVAL This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: *this device may not cause harmful interference, and *this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.