User's Manual

Product shape

Operating Instructions

1. Ensure that your stereo system is power off.

2. Plug the BT receiver into your home stereo system either by using the

included stereo cable or a standard 3.5 mm male audio cable. Plug the

AC/DC power adapter(included) into both the BT receiver and AC/DC

outlet and press the power button. The blue Status LED on the top will

being blinking.

3. Power on your home stereo system and select the audio channel input

that the BT receiver is connected to.

Bluetooth Audio Receiver LED Indicator

Mode

Pairing in process Connecting

LED Indicator

Red and blue illuminating

Blue flashing twice

every 3 seconds

Pin Code: 0000

*If Audio Receiver does not initiate any connection when power on; it simply

sits and waits for other devices’ connection. LED indicates in Red/Blue

alternate flash.

Audio Receiver

Quick Guide

PAGE 1
Audio Receiver Quick Guide Product shape Operating Instructions 1. Ensure that your stereo system is power off. 2. Plug the BT receiver into your home stereo system either by using the included stereo cable or a standard 3.5 mm male audio cable. Plug the AC/DC power adapter(included) into both the BT receiver and AC/DC outlet and press the power button. The blue Status LED on the top will being blinking. 3.
PAGE 2
Troubleshooting Receiver is not power on. z Ensure that the BT receiver power switch is in the ON position. Ensure that the AC/DC power adapter is connected into wall socket and that the plug is properly inserted into the BT receiver’s power jack. After connecting the Receiver, there is no sound. z z Make sure the audio cable is correctly plugged into the back of the BT receiver as well as to the back of the stereo system. Ensure the stereo system is set to the correct input channel.
PAGE 3
FCC Caution 1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3.