User's Manual

Product shape

Connecting my iPod Audio Transmitter

1. Turn on your Bluetooth Receiver device. The device which the iPod

transmitter is to connect. ie. Bluetooth Receiver or Stereo headset.

2. Plug the iPod transmitter into the headphone connector

3. Power on your iPod and press PLAY on the iPod. The iPod transmitter will

power on automatically. The iPod transmitter should enter pairing mode

indicated by the Red and Blue flashing alternately.

4. Enjoy!

*Note: This device will only work with Bluetooth receiver devices that

has “0000” or “1234” as PIN code.

iPod Audio Transmitter LED Indicator

Mode

Idle

Searching

last device

Pairing mode In connection

LED

Indicator

None

Red and Blue

steady

Red and Blue flash

alternately

Blue flash twice

every 3 seconds

IPod Audio Transmitter

Quick Guide

PAGE 1
IPod Audio Transmitter Quick Guide Product shape Connecting my iPod Audio Transmitter 1. Turn on your Bluetooth Receiver device. The device which the iPod transmitter is to connect. ie. Bluetooth Receiver or Stereo headset. 2. Plug the iPod transmitter into the headphone connector 3. Power on your iPod and press PLAY on the iPod. The iPod transmitter will power on automatically. The iPod transmitter should enter pairing mode indicated by the Red and Blue flashing alternately. 4.
PAGE 2
Operating Procedures 1. Upon power on, the iPod transmitter will try and connect to the last paired device for 10 seconds. If the last paired device is not found, then iPod transmitter will automatically enter pairing mode. 2. Upon disconnection, the iPod transmitter will try to reconnect to the last paired device. If the last paired device is not found, then iPod transmitter will automatically enter idle mode.
PAGE 3
FCC Caution 1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3.