User Manual

BK235/T-U7BT3 Introduction

Valet Switch: This switch is used to prevent optional Automatic Last Door

Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the system during

extended stopovers for service stations, maintenance, valet parking, washing,

etc..

The Red LED Status Light: Informs you of 7 different conditions the system can be

in and also serves as a visual deterrent to break-ins and theft.

Transmitter Operations and Features

Button I --

Pressing and releasing this button will arm the alarm.

Press Button 1 when system arm can activate the car finder function, the

parking will flash & siren will chirp for 10 times.

Button II --

Press and releasing this button will disarm the alarm.

(If this button is pressed within 3 seconds after arming the alarm, the door

protection zone and both auxiliary & built-in sensor will be bypassed.)

Button III –

Pressing and holding this button for 3 seconds when Ignition is off will

“Panic” the alarm - sounding the siren and flash the exterior lights for 30

seconds.

Press button# I Or II during panic will stop the panic.

Pressing and holding this button for 3 seconds when ignition is On will activate

the Remote Anti Hi Jack (AHJ) function.

If this button is pressed, and then the button I or II is pressed within 2 seconds,

the alarm will arm or disarm without siren confirmation chirps. (If this button is

pressed within 2 seconds after arming the alarm, the auxiliary & built-in sensor

will be bypassed.)

Button IV--

Pressing & hold this button for 3 seconds may be used to operate an additional

output for other optional devices such as remotely open the trunk.

Button III + IV

Pressing & hold both of these two buttons for 1 second can activate the 3

channel Output. The 3

channel will become active as long as these two buttons

pressed. The maximum is 30 seconds.

Arming the Security System

PAGE 1
BK235/T-U7BT3 Introduction Valet Switch: This switch is used to prevent optional Automatic Last Door Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the system during extended stopovers for service stations, maintenance, valet parking, washing, etc.. The Red LED Status Light: Informs you of 7 different conditions the system can be in and also serves as a visual deterrent to break-ins and theft. Transmitter Operations and Features Button I -Pressing and releasing this button will arm the alarm.
PAGE 2
Security System Armed and Activated Disarming the Security System Automatic Rearming: The Valet Switch And Valet Mode Valet Mode: Remotely Lock/Unlock the door in valet mode: Security Valet Override - Disarming The Security System Without The Transmitter: Exiting the Valet Mode: The Red LED Status Light The LED Status Light is used as a visual indicator of what state the security system is in at any given time.
PAGE 3
Programming Transmitters Ignition safety door lock & unlock 2 Stage safety disarm PROGRAMMABLE FUNCTION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.