User Manual

BK635/T-U7B7B/T-U7B1A/T-U7BM2 Introduction

Valet Switch: This switch is used to prevent optional Automatic Last

Door Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the

system during extended stopovers for service stations, maintenance,

valet parking, washing, etc.. The Valet Switch is also used, with the

ignition switch, to disarm the security system in the event the

transmitter becomes inoperable, and also transmitter code learning

process.

The LED Status Light: Informs you of 7 different conditions the system can

be in and also serves as a visual deterrent to break-ins and theft.

Transmitter Operations and Feature s

Button I --

Pressing and releasing this button will arm the alarm.

Pressing and holding this button for 3 seconds when Ignition is off will

“Panic” the alarm - sounding the siren or vehicle horn (if installed with

vehicle horn) flash the exterior lights for 30 seconds.

Button II --

Press and releasing this button will disarm the alarm.

Button III –

Pressing and holding this button for 3 seconds can activate the 2

channel Output.

Button IV--

Pressing & hold this button for 3 seconds can operate the 3

channel

output.

Press this button once, then press B1 or B2 within 5 seconds can

silently arm or disarm the system.

(If this button is pressed within 5 seconds after arming the alarm, the

auxiliary sensor will be bypassed.)

Button I + Button II --

Press & hold these two buttons for 3 seconds when Ignition is On can

activate the Remote Anti Hi Jack (AHJ) function.

Press B1 + B2 once when system in armed mode can active the car

finder – Siren chirp + Light flash 6 times

Arming the Security System

Active Arming The Security System Using The Transmitter:

Arm Bypass:

Shock Sensor Bypass:

Passively Arming The Security System With The Optional Last Door Arming

Feature

Arm Reminder

PAGE 1
BK635/T-U7B7B/T -U7B1A/T -U7BM2 Introduction Valet Switch: This switch is used to prevent optional Automatic Last Door Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the system during extended stopovers for service stations, maintenance, valet parking, washing, etc.. The Valet Switch is also used, with the ignition switch, to disarm the security system in the event the transmitter becomes inoperable, and also transmitter code learning process.
PAGE 2
Security System Armed and Activated Disarming the Security System Automatic Rearming The Valet Switch And Valet Mode Valet Mode Exiting The Valet Mode Security Valet Override - Disarming The Security System Without The Transmitter: The Red LED Status Light The LED Status Light is used as a visual indicator of what state the security system is in at any given time.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.