Volume 8, Select 8, Volume / Select 8, Logic Box, & Voltage Control Box Installation Guide Biamp Systems | 9300 S.W. Gemini Drive | Beaverton, OR | 97008 | USA | +1.503.641.7287 | www.biamp.
Volume 8, Select 8, Volume/Select 8, Logic Box, & Voltage Control Box are natural extensions of Audia® and Nexia® products. These controls provide an intuitive interface for end-users, and can be installed and configured to fit the unique needs of a particular application. Any combination of these controls can be connected on a 5-wire daisy-chain, eliminating the need for local power sources. This connection also provides the serial communication to the Audia or Nexia system.
Logic Input Switch Wiring (Logic Box & Voltage Control Box) Potentiometer Wiring (Voltage Control Box) high (cw) Logic w switch ccw cw ground ( ) 1 V 5~50kΩ linear taper wiper low (ccw) V (1~4) ground ( )
Programming The control operation and indicator behavior, as described below, is typical. However, controls will not become operational, until they have first been configured into a system, using the corresponding drag-and-drop icons within the design software (see Audia/Nexia software Help). Controls which are properly connected to an Audia/Nexia device, but are not yet properly associated with control blocks within the design layout, will produce only a single flashing LED, and will not be operational.
DoC CTR201003 EC Declaration of Conformity Biamp Systems Corporation, as manufacturer having sole responsibility, hereby declares that the following described product complies with the applicable provisions of the DIRECTIVES below except as noted herein. Any alterations to the product not agreed upon and directed by Biamp Systems Corporation will invalidate this declaration.
