User Guide 8-90-00178-0 Revision 1 © 2020 BI Incorporated BI Proprietary & Confidential
ii BI Proprietary & Confidential © 2020 BI Incorporated 8-90-00178-0, Revision 1
BI SL3 User Guide Preface BI SL3 User Guide Copyright © 2020 by BI Incorporated All Rights Reserved Printed in USA BI Incorporated (BI) prepared this manual for use by BI customers only. All comments concerning the contents of this manual should be directed to the BI Marketing Department, 6265 Gunbarrel Avenue, Suite B, Boulder, CO 80301, USA.
Preface BI SL3 User Guide Registrations FCC ID: CSQ-SL300A IC ID: 1499A-SL300A The FCC and IC registration numbers are located on the bottom of the unit. United States FCC, Part 15, Subpart B; ICES-003 This device complies with Part 15, subpart B of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
BI SL3 User Guide Preface Operation and EME Exposure The equipment represented herein is designed to comply with the following national and international standards and guidelines regarding exposure of human beings to radio frequency electromagnetic energy (EME): United States Federal Communications Commission, Code of Federal Regulations; 47 CFR part 2 sub-part J. American National Standards Institute (ANSI)/Institute of Electrical and Electronics Engineers (IEEE). C95. 1-2005.
Preface BI SL3 User Guide NOTE: The areas with potentially explosive atmospheres referred to above include fueling areas, such as below boat decks; fuel or chemical transfer or storage facilities; areas where the air contains chemicals or particles, such as grain, dust, or metal powders; and any other area where you would normally be advised to turn off your vehicle engine. Areas with potentially explosive atmospheres are often but not always posted.
BI SL3 User Guide Chapter 2 SL3 Device BI SL3 is a rugged, one-piece, mobile alcohol monitoring device that measures Breath Alcohol Content (BrAC) by collecting deep lung breath samples. The SL3 incorporates Adaptive Facial Recognition® (AFR®), fuel cell, and multiple acquisition technologies to ensure the client is accurately identified and tested. Test results are promptly reported to the central monitoring computer via a cellular connection.
Chapter 2 • SL3 BI SL3 User Guide Components Camera Blue Status Light Mouthpiece Port Power/Select Button LCD Display Left Display Button Right Display Button Mouthpiece Power Cord 4 BI Proprietary & Confidential © 2020 BI Incorporated 8-90-00178-0, Revision 1
BI SL3 User Guide Chapter 2 • SL3 To Activate the SL3 1. Log into TotalAccess and add the client’s Profile and Service Plan. 2. Press the power button once to turn on the SL3. 3. Select the left display button to START the process. 4. The Device ID and Security PIN will be displayed. Enter the numbers in the client’s Service Plan in TotalAccess. 5. TotalAccess communicates with the SL3 device and the device displays Activation Successful to confirm the process.
Chapter 2 • SL3 BI SL3 User Guide Rechargeable Battery The SL3 device contains an internal lithium-ion rechargeable battery. The battery lasts up to 72 hours, and takes less than five hours to charge. When powering on the SL3 device, a battery icon appears in the upper-right corner of the display showing the approximate percentage of battery power. When the battery is too low to turn on the SL3 device, the LCD will display a Connect To Power message. To charge the battery 1.
BI SL3 User Guide Chapter 2 • SL3 Cleaning & Storage After the SL3 is returned from the client, clean the unit by wiping the case with a soft cloth. You can use a disinfectant if needed. Do not use any cleaning products containing pine oil as these solvents may damage the plastic body. Store the SL3 in its original black zipper case.
Chapter 2 • SL3 8 BI SL3 User Guide BI Proprietary & Confidential © 2020 BI Incorporated 8-90-00178-0, Revision 1