User's Manual

MCW-D 50 – Control Unit

3.2.5 How to switch the Control Unit on/off

• Switch on the MCW-D 50 with the On/Off-switch on the rear.

• During the first 30 seconds the MCW-D 50 control unit is started, the Power LED and the Channel LEDs are flashing red and an

operation is not yet possible. If the MCW-D 50 control unit is connected to a network via the LAN connection , the MCW-D 50

control unit will be ready for operation after approx. 20 seconds.

• The Power LED on the front will illuminate green, when the control unit is ready for operation.

• CAUTION: Always turn off the power when making input or output connections.

Rear Front

3.2.6 Channel Indication

• Depending on the configuration of the MCW-D 50 control unit 3 or more channel-LEDs will illuminate green (standard: 3 channels).

3.2.7 Rack Mounting

• When mounting the MCW-D 50 control unit into a 19"-rack housing leave 1 HU for a ventilation panel above and under the

control unit.

• Make sure that the mains switch, mains plug and all connection on the rear of the device are easily accessible.

3.2.8 Volume Control

• The volume of the microphone units is controlled with the virtual volume control of the MCW-D 50 Conference Software.

Important:

• If the MCW-D 50 control unit is equipped with more than one module, but there are not more than 3 LEDs illuminated, please

check if individual modules have been deactivated with the MCW-D 50 Conference Software.

1 4