Wavee Touchless Switch Installation Guide INSTALLATION GUIDE, WAVEE TOUCHLESS SWITCH Page 1 of 10 BEXAR TECHNOLOGY PARTNERS revision 2
Contents Introduction .................................................................................................................................................. 3 Document Version History ........................................................................................................................ 3 Installation .................................................................................................................................................... 4 Mount Wall Plate ............
Introduction The Wavee Touchless Switch is a state-of-the-art touchless technology that can be used in residential commercial and industrial applications. • • • • • Detects motion of large bodies out to 2m Stationary objects are ignored Activates a SPSD relay for control of locks or signaling to a panel Includes an LCD and buzzer for user feedback Supports secure 2-way BLE communications with mobile devices This document provides instructions for the installation and configuration of the Wavee device.
Installation Mount Wall Plate The Wavee Touchless Switch is a two-piece assembly consisting of a detector module and a mounting plate. The detector module has four small twist grips as shown below. Twist slightly clockwise to remove the module from the wallplate. The wallplate comes with a mounting hole and mounting slot as shown below to ensure good vertical alignment. There is also a 24mm hole in the center to allow the communication cable to enter the wall.
Wiring The Wavee Touchless Switch comes with approximately 8” to 10” communication cable with 5 wires.
Operation When power is applied to the Wavee switch it will boot up for several seconds. Once it has completed booting up the LCD will display the following images for searching (idle) and detected modes. Searching Motion Detected While in searching mode the relay wires will be in their default state. When motion is detected the relay wires will switch to their opposite state and the LCD will display the motion detected image.
Configuration The Wavee device includes a Bluetooth interface that allows custom configuration and firmware updates. Navigate to the Apple or Google Play store and install the Wavee Configurator application. There are two ways to configure the Wavee device; by command or by profile. Configuration by Command Individual parameters can be configured one at a time by sending commands. 1. Launch the Wavee Configurator app and navigate to the Device Scanner page. 2.
Configuration by Profile The second method to configure the Wavee device is through a profile. This is a file saved on the device that configures all the device parameters in one go. In the following example we will disable the buzzer and relay. 1. Navigate to the Profiles tab. A list of saved profiles will be displayed. By default, the app installs two profiles that can be used as a baseline for a new profile. 2. Disable the buzzer and relay.
3. Select the Save button. A Save dialog will appear. Enter a new name and select Save. 4. The displayed device profile will now show the new profile. 5. Navigate gate back to the Saved Profiles view and you will see your profile in the list. 6. Now navigate back to the Devices tab then search for and select the desired device as done in the previous section. 7. Select the Write Profile button. A list of saved profiles will be displayed. 8. Select the desired profile.
Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.