The Lite Radio 1 Is a compact radio transmitter for the FPV entry market. This radio transmitter is portable, appealing and practical, It is a remote control suitable for FPV entry-level users. As a new member of Literate series, Literate 1 has the following characteristics. + B channels In total, » Support CC2500 version built-in protocol switching. « Configure 1000mAh battery and USB charge supported. « Support BETAKE Configuration for updating, configuring and tuning.
Bottom view BND pew SER Comparative The Literate 1 Is compatible with two types of Joystick heads. When replacing the Joystick head, please be aware not to twist the Joystick head.
backward movement of the drone; push the stick left and right to control the left and right movement of the drone; There are 7 buttons or switches on the remote control, and their functions are as following: » Channel quays: ATHABASCA quays countermand to four channel switches, and ach channel can be set to two levels of gears. ‘» Power Button: Switch the power button to the Eight to tum on, and switch the power button to the left to turn off.
How to check the current protocol The CC2500 version radio transmitter could support 4 different protocols, Including Fray D6 FCC, Fray D16 LB, Fray D8 and Rutabaga S-FESS. Tha current protocol is indicated by the flashing times of the red LED when power an, before the buzzer LED Status Protocol Version Fish once Fray D16FCC (ACCT 1X lA) Flash twice Frock D16 LET {ACCT 1.
6. Charging Remote control radio transmitter has a but-In 1000mAh battery. When the red light flashes twice and the buzzer alarms twice, indicates that radio transmitter is low battery and needs to be re-charged. Below are the charging methods for reference: « Tum off the radio transmitter. Plug In remote control radio transmitter with adapter by USB cable (5V output apter is allowed). « The LED light brashest in red means charging, wheel in groan means fully charged.
Operation steps below: » Turn off radio transmitter. + Connect the transmitter to computer via USB data cable. Walt for the LED light breathes in red or green. » Install driver from PC automatically, prompt box pops up after successful installation. Then, remote control radio transmitter works normally. Other devices Ep PEAR daybreak User needs to manually install driver if PC doesn't install automatically or installed Incorrectly. 30 NOT power on the transmitter fst and connect 1 to the PC.
» After powering on, press SETUP button on the back of remote control radio transmitter, it hears two "Bee Bee" sounds, and red LED flash quickly {two flashes ‘each time), which means remote control radio transmitter entered calibration mode.
. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful Interference, and (2) this device must accept any Interference received, Including Interference that may cause undesired ‘operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
safety of al persons regardless of age or health. FCC RF Exposure Information and Statement. « This radio Is designed for and classified as “General population/uncontrolied Use”, the guidelines are based on standards they were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.