Operator's Manual
Page 1
12V Wireless Remote Control (7771938)
(Wireless Remote Control On/Off Switch, 12 Volt)
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[(10/22)]
INSTALLATION/OPERATION
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-800-831-0027
MONDAY-FRIDAY, 8:00 AM TO 5:00 PM CST
If you should have a question or experience a problem with
your Fimco Industries Product: Visit our website @
www.fimcoindustries.com or call the Toll free number above. Our
technical support representatives will be happy to help you.
In most cases a customer service rep. can resolve
the problem over the phone.
To obtain prompt, efficient service, always remember to give the
following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
General Information
Thank you for purchasing this product. The purpose of this
guide is to assist you in installing, operating and maintaining
your wireless remote
Retain a copy of your receipt for your unit, as it will be required
to validate any warranty service.
Warranted against manufacturer or workmanship defects from
date of purchase with copy of receipt:
Homeowner Usage: One Year.
Commercial Usage: 90 Days.
WARNING: Cancer and Reproducve Harm.
www.P65Warnings.ca.gov
WARNING: To reduce the risk of injury, the
user must read and understand the operator’s
manual before using this product.
Operang instrucons:
(Two) 2-Pin wire connectors, one for power-in and the other
for power-out.
Power-in connector is idened by the black and red wire.
Power-out connector is idened by the blue and red wire.
In addion, the power-in and power-out connectors are
labeled on the receiver housing. The Power-in connector
(black and red wire) will plug into the lead wire assembly
connected to the power source usually from the operang
vehicle. The Power-out (blue and red wire) will plug into the
connector located on the pump. A red LED light will illuminate
on the receiver once the connecons are made, and power is
applied. (If the red LED does not illuminate check for proper
connecons and power supply). With the red LED light illumi-
nated, the pump can be operated using the on/o buons on
the remote.
For troubleshoong, the following needs to be checked:
Terminals connected properly. Power-in connected to
power source and power out connected to pump
connector.
Red LED light indicates power is connected properly.
Check power source and fuse in Lead wire assembly if
light does not illuminate.
Check 23A 12V baery in remote. Change out if necessary.