Instruction Manual

Instruction Manual
X15
Indicator Light
Full Power
No Power
Charging Contacts
Battery Indicator
Connect
Before Use
Reset
Please read the instructions before use
English
Wipe and dry charging contacts
if earbuds can’t be charge.
！
2. After open the phone
Bluetooth, Click the <X15>
to Pairing
1. Take out the earbuds
(Earbuds auto power on)
Bluetooth
Device name K30 >
If earbuds has any connection or function problems,
please reset the earbuds
1. Delete the BT pairing information on the phone.
2. Take the earbuds into the charging case to charge.
3. Take out the earbuds and wait for 20 seconds.
(If the above operation does not work, please try again)
Operation
X2
2S
Switch Song Adjust Volume
X1
X1: Click Once
X2: Click 2 times
Play /Pause
-
+
Bluetooth
Device name
Available Devices
X15
Nova7 >
Pairing Charging
Flashing No Light Red
Connected
X1
Answer/Hang up
Power on/off
（When no conected）
2S
2S： Press and hold for 2 seconds
5S
Reject Call
X3
Voice Assistant
Siri
1. Fully charge the earbuds and charging case.
2. Choose the right angle and eartips.
S M L
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
FCC Statement: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for
help.