Installation Guide

INSTRUCTIONS:
1. Remove the Metal Garden Hose
®
from the package and completely
unravel your Metal Garden Hose
®
.
2. Attach the spray nozzle (included) to the outlet of the Metal
Garden Hose
®
(figure 1). Make sure 1 silicone washer is in place.
3. Attach the Metal Garden Hose
®
inlet to the water supply of your
home (figure 1). Make sure 1 silicone washer is in place.
4. Turn on the faucet from your home’s water supply to the Metal
Garden Hose
®
.
NOZZLE CLEANING: (DO NOT DISASSEMBLE WHILE PRESSURIZED)
For long life, the Metal Garden Hose
®
Pro Series Aluminum Nozzle is designed to be disassembled and
cleaned should your nozzle become clogged.
1. Hold the inlet of the nozzle and turn spray adjuster counter clockwise to
unscrew from base.
2. Rinse or wipe any debris from nozzle internals (careful of o-rings).
3. Dry with clean towel or cloth.
4. Reassemble nozzle, by screwing spray adjuster clockwise until spray
adjuster comes to a stop. This is the off position, do not over tighten.
Open
Closed
2022 © Yeiser Research & Development and Metal Garden Hose
®
.
Trade names, product names, patterns, prints, images
and logos used in this document are the trademark or registered trademarks of YRD LLC, Santee, CA 92071
WORLD WIDE PATENTS PENDING
MGHI00179_03 rev12a
PRO SERIES
Inlet, screw female
connector end to
faucet (water supply)
screw nozzle
to outlet end
of hose.
Outlet
* Please Note: Your hose may come with an extra silicone washer. There
should only be one washer per connection. Two washers doubled up in the
spray nozzle or in the inlet can cause leakage.
www.berninifountains.com
LIMITATION OF LIABILITY
Liability limited to the purchase price of this product.
YRDLLC shall not be liable for any incidental or
consequential damages or any implied warranty on
this product.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
www.berninifountains.com
For Assistance Call: 1 [phone]
TIP: When you are nished watering with your
Metal Garden Hose® It’s best to release the
water pressure from your hose
before storing.
You can store your Metal Garden Hose
®
on just about any common
hose reel or simply coil your hose next to your faucet.
Silicone Washer*
Silicone Washer*
Scan this QR code for
the latest version of these
instructions
Remember if you need help contact Customer Care: 1+ [phone]
WARNING
• The water in ANY garden hose may become contaminated and
cause serious health effects.
• Strangulation hazard. Hose wrapped around neck may cause
serious injury or death.
• Keep out of reach of children.
• For general OUTDOOR use ONLY in applications under 80 psi.
• DO NOT use this hose for commercial applications, in hot
water applications, or high pressure applications. Doing so
may cause serious personal injury and or damage/ destruction
to the product.
However you can use it on the low pressure inlet side of a high
high pressure washer.
• DO NOT leave this product unattended when it is in use or under
pressure.
• This product is NOT A TOY.
For warranty information please refer to our website at: www.berninifountains.com/pages/warranty-info.html. Call us for assistance
at [phone] or you can email or mail us at: 9545 Pathway Street, Santee, CA 92071 [e-mail]
Our Customer Care Department is available: Monday - Friday 8:30am to 4:00pm PST / 11:30am - 7:00pm EST
LIMITED ONE YEAR WARRANTY