Quick Installation Guide

ManualsBrandsBernafon ManualsElectronicsHearing Aid Module

Table Of Contents

Oticon Radio Model - Regulatory Label Information for USA & Canada
- This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada.
  - Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

Bernafon Radio Model - Quick Installation Guide Radio Model

Name: Bernafon BTE SP

The Bernafon BTE SP radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform.

The radio model is implemented in an engine module mounted on the main PCB with connections to the antennas, the microphones, the speaker and the

battery terminals.

The 3.84 MHz radio is a low power, short range, inductive radio transceiver working at a single channel at 3.84 MHz using MSK modulation with 320 kbit/s

data rate and connected to a small coil antenna. The 2.4 GHz radio is a Bluetooth Low Energy (BLE) transceiver using GFSK modulation with 1 Mbit/s data

rate also capable of proprietary receiver modes with higher data rates and connected to a short PCB antenna.

Summary of content (4 pages)

PAGE 1
Bernafon Radio Model - Quick Installation Guide Radio Model Name: Bernafon BTE SP The Bernafon BTE SP radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform. The radio model is implemented in an engine module mounted on the main PCB with connections to the antennas, the microphones, the speaker and the battery terminals. The 3.84 MHz radio is a low power, short range, inductive radio transceiver working at a single channel at 3.
PAGE 2
Bernafon Radio Model - Quick Installation Guide Radio Model Name: Bernafon BTE SP Below the main flex PCB of the Bernafon BTE SP radio model with the most important electrical and electro-mechanical components can be seen: Bernafon BTE SP Radio Model – Main PCB – Top side The most important part of the radio model is the Engine Module mounted on the main flex PCB, which connects it to both the EEPROM memory and all external connections: On the top side these are the microphones, the battery terminals and
PAGE 3
Bernafon Radio Model - Quick Installation Guide Radio Model Name: Bernafon BTE SP On the bottom side of the main PCB of the Bernafon BTE SP radio model the connector for the speaker unit assembly (where the wire antenna for the Bluetooth radio is an integrated part), the programming connector, EEPROM memory and coil antenna for the 3.
PAGE 4
Bernafon Radio Model - Regulatory Label Information for USA & Canada Radio Model Name: Contains: FCC ID: IC: Bernafon BTE SP U6XBEBTESP 7031A-BEBTESP NOTICE: This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.