Installation Instructions

ManualsBrandsBernafon ManualsElectronicsHearing Instrument amplifier module

Aurora

BTE

power

Oticon

Radio

Model

Quick

Installation

Guide

Radio

Model

Name:

Bernafon AG

Morgenstrasse 131 Phone +41 31 998 15 15

P.O. Box 550 Fax +41 31 998 15 90

CH-3018 Bern, Switzerland info@bernafon.ch, www.bernafon.com

The Aurora BTE power radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform.

The radio model is implemented in an engine module mounted on the

main PCB with connections to the antennas, the microphones, the speaker

and the battery terminals. The radio model can be seen in 3D overview to

the left:

The 3.84 MHz radio is a low power, short range, and inductive radio

transceiver working at a single channel at 3.84 MHz using MSK

modulation with 320 kbit/s data rate and connected to a small coil

antenna. The 2.4 GHz radio is a Bluetooth Low Energy (BLE)

transceiver using GFSK modulation with 1 Mbit/s data rate also capable

of proprietary modes with higher data rates and connected to a short PCB

antenna.

Aurora BTE power Radio Model – 3D overview

Summary of content (5 pages)

PAGE 1
Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora BTE power The Aurora BTE power radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform. The radio model is implemented in an engine module mounted on the main PCB with connections to the antennas, the microphones, the speaker and the battery terminals. The radio model can be seen in 3D overview to the left: The 3.
PAGE 2
Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora BTE power Below the main flex PCB of the Aurora BTE power radio model with the most important electrical and electro-mechanical components can be seen: Aurora BTE power Radio Model – Main PCB – Top side The most important part of the radio model is the Engine Module mounted on the main flex PCB, which connects it to both the EEPROM memory and all external connections: On the top side, these are the microphones, the battery terminals,
PAGE 3
Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora BTE power On the bottom, side of the main PCB of the Aurora BTE power radio model the connector for the speaker unit assembly (where the wire antenna for the Bluetooth radio is an integrated part), the programming connector, and EEPROM memory and coil antenna for the 3.
PAGE 4
Oticon Radio Model - Regulatory Label Information for USA & Canada Radio Model Name: Contains: FCC ID: IC: Aurora BTE power U6XAUBTEP 7031A-AUBTEP NOTICE: This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
Oticon Radio Model - Regulatory Label Information for Japan Radio Model Name: Aurora BTE power Description: Radio module with 2.4 GHz low power transceiver to be integrated into Oticon, Bernafon, Sonic hearing instruments and associated devices. Regulatory label: NB: The NB: The regulatory label for Japan is also included in the IFU for Japan.