Product Info

- 5 -

FCC REGULATIONS

WARNING : Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

1. This equipment complies with Part 68 of the FCC rules and the requirements

adopted by the ACTA. On the bottom of this equipment is a label that contains, among

other information, a product identifier in the format US : AAAEQ##TXXXX. If

requested, this number must be provided to the telephone company.

2. The USOC number of the registration jack for the equipment is RJ11C.

3. A FCC compliant telephone cord and modular plug is provided with this

equipment. This equipment is designed to be connected to the telephone network or

premises wiring using a compatible modular jack which is Part 68 compliant. See

Installation Instructions for details.

4. The REN is used to determine the quantity of devices which may be connected to

the telephone line. Excessive RENs on the telephone line may result in the devices not

ringing is response to an incoming call. In most, but not all areas, the sum of RENs

should not exceed five (5.0). To be certain of the number of devices that may be

connected to a line, as determined by the total RENs, contact the local telephone

company.

5. If this terminal equipment causes harm to the telephone network, the telephone

company will notify you in advance that temporary discontinuance of service may be

required. But if advance notice isn’t practical, the telephone company will notify the

customer as soon as possible. Also, you will be advised of your right to file a complaint

with the FCC if you believe it is necessary.

6. The telephone company may make changes in it’s facilities, equipment,

operations or procedures that could affect the operation of the equipment. If this happens

the telephone company will provide advance notice I order for you to make necessary

modifications to maintain uninterrupted services.

7. The equipment cannot be used on public coin phone service provided by the

telephone company. Connection to party line service is subject to state tariffs.

8. Please follow instructions for repairing if any (e.g. battery replacement

section), otherwise do not alternate or repair any parts of device except specified.

9. This equipment if it uses a telephone handset is hearing aid compatible.

10. If trouble is experienced with this equipment, for repair or warranty information,

please contact service centre at the below. If the equipment is causing harm to the

PAGE 1
FCC REGULATIONS WARNING : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 1. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US : AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. 2.
PAGE 2
telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. Service can be obtained at: Beat Sounds Inc. 14515 Valley View Ave. #B Santa Fe Springs, CA90670 Phone: 1-562-407-0227 INTERFERENCE INFORMATION: PART 15 OF FCC RULES Some telephone equipment generates and uses radio frequency energy, which if not properly installed, may causer interference to radio and television reception.