H158A-S SPEC
H158A-S SPEC Content 1. General Description ...................................................................................................................................3 2. Product Model Information ....................................................................................................................3 3. WIFI Specification .......................................................................................................................................3 3.1 WIFI features ..........
H158A-S SPEC 1. General Description H158A-S is a highly integrated and excellent performance Wireless LAN (WLAN) SDIO2.0 network interface device. Based on iCOMM chipset SV6158P. support 802.11b/g/n standard. 2. Product Model Information Model Number H158A-S FCC ID 2AN2O-RSW04 IC 23317-RSW04 3. WIFI Specification 3.1 WIFI features a) Operate at ISM frequency Band (2.4GHz); b) IEEE standards support, 802.
H158A-S SPEC 3.2 WIFI RF Performance Feature Description Standard IEEE 802.11 b/g/n 802.11 b: 11, 5.5, 2, 1 Mbps 802.11 /g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps Data Rate 802.11 n: MCS 0 to 7 for HT20MHz:65 Mbps MCS 0 to 7 for HT40MHz:150 Mbps IEEE 802.11b mode: CCK, DQPSK, DBPSK Modulation mode IEEE 802.11g mode: 64QAM, 16QAM, QPSK, BPSK IEEE 802.11n mode : 64QAM, 16QAM, QPSK, BPSK Ad-hoc Mode(Peer-to-Peer) Network Architecture Infrastructure mode Scatter Net Frequency Range 2.400 GHz ~ 2.
H158A-S SPEC 3.3 Block Diagram 3.
H158A-S SPEC 3.5 PIN Assignment Pin # Name Description 1 GND GND 2 ANT RF OUTPUT 3 GND GND 4 NC NC 5 GPIO12 6~8 NC NC 9 VCC33 3.
H158A-S SPEC 16 SDIO_DATA_CMD SDIO_CMD, GPIO19 17 SDIO_DATA_CLK SDIO_CLK, GPIO20 18 SDIO_DATA_D0 SDIO_D0, GPIO21 19 SDIO_DATA_D1 SDIO_D0, GPIO22 20 GND GND 21 NC NC 22 VDIO 1.8 or 3.3V 23~30 NC NC 31 GND GND 32 NC NC 33 GND GND 34~35 NC NC 36 GND GND 37 GPIO01 UART LOG TX 38 GPIO00 UART LOG RX 39~44 NC NC 3.
H158A-S SPEC 4. Antenna Specification 4.1 Antenna lists Max No. Type Band(s) 1 PCB antenna 2.4GHz - 2.5GHz 3.7 2 PCB antenna 2.4GHz - 2.5GHz 3.3 roborock S6 3 PCB antenna 2.4GHz - 2.5GHz 4.2 roborock S4 4 PCB antenna 2.4GHz - 2.5GHz 3.7 roborock S5 Max 5 PCB antenna 2.4GHz - 2.5GHz 3.7 S5 Max Peak Gain(dBi) Host Model S501-01, S511-01, S551-01 4.2 Wireless LAN antenna matching circuit 4.
H158A-S SPEC b) Antenna is 2.4G WiFi Frequency band MIFA type Board antenna c) Antenna length, width, shape(s) as follows,Company:mm; d) PCB thickness is 1.5mm,Copper-Layer 6,Antenna is Layer1; e) Antenna put on the edge of the pcb,Clearance around and below; 5. FCC and IC Warning This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s).
H158A-S SPEC may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
H158A-S SPEC Les antennes installées doivent être situées de facon à ce que la population ne puisse y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’ antenne. La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné d’au moins 20 cm des personnes pendant son functionnement.