Users Manual

ManualsBrandsBeijing Niu Technology ManualsElectronicsBluetooth module

1. WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

2.Product features

The C22H module is designed to offer high integration, ultra‐low power application

capabilities. The system’s block diagram is as follow.

It embeds Flash, LDO and DCDC, crystal, RF match network and etc. With the high

integration level of the module, few external components are needed to satisfy customers’

ultra‐low cost requirements.

Its typical applications include, but are not limited to the following:

Smartphone and tablet accessories

RF Remote Control

Sports and fitness tracking

Wireless toys

Smart Lighting, Smart Home devices

Summary of content (6 pages)

PAGE 1
. WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2.Product features The C22H module is designed to offer high integration, ultra‐low power application capabilities. The system’s block diagram is as follow. It embeds Flash, LDO and DCDC, crystal, RF match network and etc.
PAGE 2
3.Key features 2.1 General features  3 GPIOs.  UART with hardware flow control and 7816 protocol support.  Swire debug Interface.  Operating temperature range: ‐30℃~+50℃  Supports BLE, BLE Mesh, RF4CE and 2.4GHz proprietary technologies into a single SoC without the requirement for an external DSP 2.2 Flash features C22H module embeds Flash with features below: 1) Total 512kB (4Mbits). 2) Flexible architecture: 4kB per Sector, 64kB/32kB per block. 3) Up to 256 Bytes per programmable page.
PAGE 3
4. Pin layout TOP view 5.Pin functions No Pin Name Type Description 1 GND GND GND 2 ANT Analog RF singal 3 GND GND GND 4 IO1 Digital I/O General input/output 5 VBAT PWR Power, 3.3V max power 6 VBAT PWR Power, 3.
PAGE 4
6.Schematic 7. Size 13.4(mm)*11.4(mm)*2.8(mm) 8.Absolute maximum ratings FCC Statement FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.
PAGE 5
PCB Antenna with antenna gain ‐1dBi We will retain control over the final installation of the module such that compliance of the end product is assured. In such cases, an operating condition on the limit module approval for the module must be only approved for use when installed in devices produced by a specific manufacturer.
PAGE 6
such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains 2AQ95‐C22H”. Information that must be placed in the end user manual: The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user's manual of the end product which integrates this module.