User's Manual

HAND HELD DIGITAL TRANSMITTER

1 Descri

tion

The T306 Series Transmitter is ideal for the opening, closing the garage door and control the winch of

hoist machine. The Transmitter is available in hand-held and transmits a unique code each time the switch

is closed to provide a secure control. The transmitter is powered by a 12-volt battery and a blue indicator

light when the transmitter is activated.

2 S

ecifications

DESCRIPTION SPECIFICATION

FREQUENCY 434MHz

EMITTED RADIO POWER <5dBm

POWER CONSUMPTION Max 9mA

OPERATING TEMPERATURE -10˚C~+55˚C

DIMENSIONS 75mmx38mmx13mm

CERTIFICATION FCC

3 Batter

lacement

1.Remove screw from back of transmitter.

2.Separate housing and install a fresh 12-Volt/23A ALKALINE battery making sure to observe

properly polarity.

3.Reassemble housing and replace screw.

CANSEC T306 / T306-2 TRANSMITTERS

RF MODULE &

SECURIT

PRODUCTS USER’S GUIDE

T306 T306-2 T306 T306-2

PAGE 1
CANSEC T306 / T306-2 RF MODULE & SECURITY PRODUCTS TRANSMITTERS USER’S GUIDE HAND HELD DIGITAL TRANSMITTER 1 Description The T306 Series Transmitter is ideal for the opening, closing the garage door and control the winch of hoist machine. The Transmitter is available in hand-held and transmits a unique code each time the switch is closed to provide a secure control. The transmitter is powered by a 12-volt battery and a blue indicator light when the transmitter is activated.
PAGE 2
1 4 FCC Compliance 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.