User's Manual

USER MANUAL

T106 REMOTE TRANSMITTER

INSTALLATION INSTRUCTION

This option controls the engine run time for remote start.

SPECIFICATION

1. Power Supply: 6V ( CR2016*2Battery )

2. Current Consumption: Standby Consumption： < 3uA

Operating Consumption: <25mA

3. Frequency: 433.92MHz

4. Frequency Tolerance: ± 300KHz

5. Modulation: OOK (On Off Key / ASK)

6. OSC With SAW Resonator: SAW oscillator plus antenna buffer

7. Hopping code MCU Encoder: Highly security private hopping

code by MCU CS616

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Remote Start

PAGE 1
USER MANUAL T106 REMOTE TRANSMITTER INSTALLATION INSTRUCTION Remote Start This option controls the engine run time for remote start. SPECIFICATION 1. Power Supply: 6V ( CR2016*2Battery ) 2. Current Consumption: Standby Consumption： < 3uA Operating Consumption: <25mA 3. Frequency: 433.92MHz 4. Frequency Tolerance: ± 300KHz 5. Modulation: OOK (On Off Key / ASK) 6. OSC With SAW Resonator: SAW oscillator plus antenna buffer 7.
PAGE 2
class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.