User's Manual

Smart Key Finder
Quick Start Guide
Box Content:
Pally Smart Key Finder key fob: one with 2xAAAA batteries installed
Metal key ring: one
Setup
1. Download and install the free Pally Smart Finder
app from Apple App store (scan QR code for fast
access or visit http://PallyTech.com/KF-4A.
Alternative, you can search
for Smart Finder in App Store.
2. Launch the Smart Finder app.
If the Bluetooth is turned off
on your iOS device, please
follow the on-screen display to enable Bluetooth.
After that, launch the Smart Finder app again.
3. Follow the following three steps to pair up your key fob and iOS device.
a. On the key fob, press “P” button once to activate the device.
b. In Smart Finder app, tap the “+” to add a new device. Follow the
instruction on the iOS device screen.
c. Once the key fob is discovered, press and hold the “P” button for
3 seconds to pair them up.
Customer Support
If you have any question, please contact our support team at
http://PallyTech.com/support
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.

Summary of content (1 pages)