Product Description

Product Description：
Dimensions (Unit：mm)
Installation diagram
348
119
76
30
1.Remove the speed gate door cover.
2.Remove the base bracket inside the speed gate door cover, tighten the identification terminal to
the base with screws (M4*9.5), (a rubber gasket can be used to adjust the gap between the base
and the cover), then put the base bracket back in place.
3.Fix the base to the base bracket with screws (M4*9.5), adjust all the screws after adjusting the
identification terminal to the ideal angle, ensure identification end fixed to the base bracket.
4.Install the interface module into the reserved installation position in the speed gate door with
screws (M3*6).
5.Connect the two cables (Cable A and Cable B) from the identification terminal to the
corresponding interfaces on the interface board.
Note
1
：
Please attention insert direction of the Cable A ,refer to the "
Figure 2 ".
6.Reinstall the speed gate cover.
All operations must be finished by the professional installers.
Manual
Identification Terminal
The speed gate cover
Base bracket fixing nut
※
M4*9.5 screw
Base bracket
※
Base
M4*9.5 screw
Interface module(optional)
Rubber gasket
Cable A
Cable B
(“IB”up)
※
Non-standard packaging accessories
Figure 1
Figure 2
Figure 3
The product is a Biometric Recognition Device system which contains Identification
Terminal,Interface module(optional),and the gate control part.
The system is an intelligent channel management and control device with integrates QR code
recognition, license reading and face recognition functions. It is based on TCP/IP network
communication and uses synchronous data backup with the SaaS platform.
The system is an intelligent terminal device based on block-and-pass behavior which combines
with face recognition technology to achieve personnel identification and passage control so as to
enhance safety management.
Installation instructions：