TUBE CONDENSER MICROPHONE User Manual A50-28033-00001 T‑1
TUBE CONDENSER MICROPHONE T‑1 1. At a glance 4. Connect the mains cable 5. Switch on the PSU-T 7. And you’re good to go! 2. Connect the microphone to the PSU-T 6. Allow the tube to warm up 1. Mount the microphone 3. Connect the PSU-T to the mixer 2. Safety precautions Please read all safety precautions and operating instructions before attempting to operate the unit. Keep all safety precautions and operating instructions for future reference.
TUBE CONDENSER MICROPHONE T‑1 a bathtub, washing machine, swimming pool,etc.). When doing voice recordings, always use the enclosed windscreen to protect the capsule from moisture. PSU‑T power supply: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside. Do not defeat the safety purpose of the polarized or grounding-type plug. You should only connect the T‑1 to the provided power supply.
TUBE CONDENSER MICROPHONE T‑1 The POWER switch on the unit's rear panel turns on the power supply. Here you also find the following: == a seven-pin XLR connector to connect to the T‑1 (MIC), == a three-pin XLR connector to transmit the signal (OUTPUT), == a switch to suppress signal humming noise (GND LIFT), == an IEC power receptacle == and a fuse holder. ++ Use the provided cable to connect the T‑1 to the power supply unit! 4.
TUBE CONDENSER MICROPHONE T‑1 controls in the microphone channel should be set to mid-travel position to start with; low-cut filter and signal level attenuation should be switched off. To get the sound you want, try changing the mic position relative to the sound source or even move the microphone around in the recording room of your studio. Adjusting the angle at which walls face the sound source can also be helpful.
TUBE CONDENSER MICROPHONE T‑1 8. Specifications Transducer type Polar pattern Preamplifier Output (PSU-T) Open circuit sensitivity Frequency response Level attenuation Low-cut filter Max. SPL (3 % THD @ 1 kHz) Dynamic range Nominal impedance Load impedance Supply voltage Mains voltage / Fuse 100-120 V~, 50/60 Hz 220-230 V~, 50/60 Hz Mains connector Dimensions Weight (net) condenser, 16 mm (0.
