User Manual ULTRA-G GI100 Professional Battery/Phantom Powered DI-Box with Guitar Speaker Emulation
ULTRA-G GI100 User Manual Table of Contents Thank you.................................................................................. 2 Important Safety Instructions................................................. 3 Legal Disclaimer........................................................................ 4 Limited Warranty...................................................................... 5 1. Controls............................................................................... 10 2.
ULTRA-G GI100 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
ULTRA-G GI100 User Manual other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 10. Use only attachments/accessories specified by the manufacturer. 11.
ULTRA-G GI100 User Manual ABSOLUTELY NO AUTHORITY TO BIND MUSIC GROUP BY ANY EXPRESS OR IMPLIED UNDERTAKING OR REPRESENTATION. THIS MANUAL IS COPYRIGHTED. NO PART OF THIS MANUAL MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY PURPOSE, WITHOUT THE EXPRESS WRITTEN PERMISSION OF MUSIC GROUP IP LTD. ALL RIGHTS RESERVED. © 2013 MUSIC Group IP Ltd. Trident Chambers, Wickhams Cay, P.O.
ULTRA-G GI100 User Manual Welcome to BEHRINGER! In addition to the numerous advantages of an excellent DI box, the GI100 features an extremely authentic, pure analog simulation of a 4 x 12" guitar speaker cabinet. On stage and in the studio, it is often desirable to directly connect sound sources with the console. Although this method has many advantages, it also has its technical hurdles.
ULTRA-G GI100 User Manual The GI100 features a switchable speaker simulation, developed in collaboration with renowned amp designer Jürgen Rath, which adds the sound of a 4 x 12" cabinet to your direct guitar signal at the touch of a button. Analog speaker simulations, offering the possibility to get a typical guitar cabinet sound to tape or to a PA without the necessity of cabinets or microphones, have been available since the mid-80’s.
ULTRA-G GI100 User Manual (4) BATTERY COMPARTMENT. To install or replace the 9 V battery, remove the screw and lift the lid. (5) The CLIP LED lights up when the input signal level is too high. (6) The two -20 dB PAD switches noticeably increase the operating range of the ULTRA-G, allowing it to accept anything from the low-level signal of a high-impedance microphone or guitar to the loudspeaker output of a guitar amp. These switches have repeatedly proven themselves in the BEHRINGER ULTRA-DI DI100.
ULTRA-G GI100 User Manual 2. Connection examples The following section illustrates various applications of the ULTRA-G GI100. 2.1 Conversion of guitar signals VIRTUAL 4 x 12" CAB Simulation ON/OFF OUT IN Mic Inputs IN VIRTUAL 4 x 12" CAB Simulation ON Power Amp OUT IN OUT DIRECT LINK TO CABINET Fig. 2.1: 1. Guitar ➟ GI100 ➟ Console 2.
ULTRA-G GI100 User Manual 2.2 Picking up a bass guitar or keyboard signal IN VIRTUAL 4 x 12" CAB Simulation ON/OFF Monitor Amp OUT DIRECT LINK Mic Inputs Bass Amp DIRECT LINK OUT IN VIRTUAL 4 x 12" CAB Simulation ON/OFF Fig. 2.2: 1. Bass guitar ➟ GI100 ➟ Amplifier/Console 2. Keyboard ➟ GI100 ➟ Amplifier/Console This diagram illustrates two standard DI applications.
ULTRA-G GI100 User Manual 2.3 Converting a microphone signal from high-impedance unbalanced to low-impedance balanced Many inexpensive microphones have unbalanced high-impedance outputs. With the ULTRA-G, these microphones can be used in spite of long cable runs without the danger of hum or other interference. Simply insert the GI100 between the microphone and the console. For this application, you will most likely want to switch the VIRTUAL CAB speaker simulation off. 2.
ULTRA-G GI100 User Manual 3. Specifications Frequency response 10 Hz to 160 kHz Noise -99.2 dBu Distortion < 0.014% (1 kHz, 0 dBu in) Input resistance > 250 kOhm Connection impedance > 600 Ohm Input 1/4" mono jack Output XLR balanced Max. input level +8/ +28/ +48 dBu (Simulation OFF) -2/ +18/ +38 dBu (Simulation ON) Supply: Phantom supply 18 V DC to 48 V DC Battery 9 V 6LR91 Dimensions 150 x 130 x 60 mm (6 x 5 x 2.4") Weight approx.
We Hear You