UBB1002 EURORACK User’s Manual Version 1.
EURORACK UBB1002 IMPORTANT SAFETY INSTRUCTIONS CAUTION: 12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel.
EURORACK UBB1002 EURORACK Ultra Low-Noise Design 10-Input 2-Bus Mic/Line Mixer with Optional Battery Operation V 2 new state-of-the-art, studio-grade IMP "Invisible" Mic Preamps with: - 130 dB dynamic range for 24-bit, 192 kHz sampling rate inputs - Ultra-wide 60 dB gain range - Lowest possible distortion 0.
EURORACK UBB1002 FOREWORD TABLE OF CONTENTS Dear Customer, I’m sure you’re one of those people who have devoted themselves body and soul to your chosen area and no doubt this has transformed you into an expert in your field! Well, for over 30 years, my passion has been music and electronics. This not only led me to establish BEHRINGER, but also enabled me to convey and share my enthusiasm with my employees.
EURORACK UBB1002 1.2 Power supply 1. INTRODUCTION Congratulations! With the UBB1002 you have purchased a state-of-the-art 10-channel mixing console that sets new standards. Our prime goal when developing the UBB1002 was to design a console that can be used for a great variety of applications. And to give you maximum flexibility, you can operate the UBB1002 both from the mains and from batteries.
EURORACK UBB1002 1.3.2 Front panel 1.3.3 Main section The LEVEL DISPLAY reads the output level of your UBB1002. Make sure that the two Clip LED’s won’t light up. The mono channels 1 and 2 of your UBB1002 feature the same control elements. Therefore, the following description of channel 1 also applies to channel 2. Use this switch to activate the phantom power required for condenser microphones.
EURORACK UBB1002 2. WIRING Fig. 2.5: Stereo plug for headphones connection 3. SPECIFICATIONS Fig. 2.1: 1/4" mono plug INPUT CHANNELS 1 & 2 Mic input Frequency response Gain range SNR Line inputel Frequency response Gain range SNR electronically balanced, discrete input configuration 10 Hz to 200 kHz +14 dB to +60 dB 120 dB E.I.N. ectronically balanced 10 Hz to 130 kHz -6 dB to +38 dB 95 dB E.I.N. STEREO CHANNELS 3/4 - 7/8 & 9/10 Frequency response Gain range Fig. 2.
EURORACK UBB1002 4. WARRANTY § 1 OTHER WARRANTY RIGHTS AND NATIONAL LAW 1. This warranty does not exclude or limit the buyer’s statutory rights provided by national law, in particular, any such rights against the seller that arise from a legally effective purchase contract. 2. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law. 2.