User Manual EURORACK UB1202/UB1002 Ultra-Low Noise Design 12/10-Input 2-Bus Mic/Line Mixer UB802/UB502 Ultra-Low Noise Design 8/5-Input 2-Bus Mixer
EURORACK UB1202/UB1002/UB802/UB502 User Manual Table of Contents Thank you........................................................................ 2 Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited warranty............................................................. 3 1. Introduction................................................................ 4 1.1 General mixing console functions.........
EURORACK UB1202/UB1002/UB802/UB502 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 1. Introduction The range of inputs and outputs comprises microphone inputs (with +48 V phantom power supply), line inputs, possibilities for connecting effects devices, connectors for a 2-track master machine (e.g. DAT recorder) and a monitor system consisting of monitor loudspeaker(s) and power amplifier (except for UB502).
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2. Control Elements and Connectors This chapter describes the various control elements of your mixing console. All controls, switches and connectors will be discussed in detail. 2.1 Mono channels 2.1.1 Microphone and line inputs EQ The upper (HI) and the lower band (LO) are shelving filters that increase or decrease all frequencies above or below their cut-off frequency.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.2 Stereo channels 2.2.1 Stereo line inputs BAL The BAL(ANCE) control determines the levels of left and right input signals relative to each other before both signals are then routed to the main stereo mix bus. If a channel is operated in mono via the left line input, this control has the same function as the PAN control used in the mono channels. LEVEL Fig. 2.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.3.2 Monitor and main mix Alternatively the line or tape output of a hi-fi amplifier with source selection switch could also be hooked up here, allowing you to easily listen to additional sources. TAPE OUTPUT These connectors are wired in parallel with the MAIN OUT and carry the main mix signal (unbalanced). Connect the TAPE OUTPUT to the inputs of your recording device.
EURORACK UB1202/UB1002/UB802/UB502 User Manual +48 V 3.2 Audio connections The red +48 V LED lights up when phantom power is on. The PHANTOM switch activates the phantom power supply on the XLR connectors of all mono channels. You will need a large number of cables for different applications. The illustrations below show how the connectors should be wired. Be sure to use only high-grade cables.
EURORACK UB1202/UB1002/UB802/UB502 User Manual Balanced ¼" TRS connector strain relief clamp sleeve ring tip sleeve ground/shield ring cold (-ve) tip hot (+ve) For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug. Fig. 3.3: 1/4" stereo plug ¼" TRS headphones connector strain relief clamp sleeve ring tip sleeve ground/shield ring right signal tip left signal Fig. 3.
EURORACK UB1202/UB1002/UB802/UB502 User Manual 4. Specifications Mono Inputs Equalizer Microphone Inputs (IMP “Invisible” Mic Preamp) EQ Mono Channels Type XLR connector, electronically balanced, discrete input circuit Mic E.I.N.1 (20 Hz - 20 kHz) @ 0 Ω source resistance -134 dB / 135.7 dB A-weighted @ 50 Ω source resistance -131 dB / 133.3 dB A-weighted @ 150 Ω source resistance -129 dB / 130.5 dB A-weighted Frequency Response LOW 80 Hz / ±15 dB MID 2.
EURORACK UB1202/UB1002/UB802/UB502 User Manual Power Supply Power Consumption UB1202: 23 W UB1002: 18 W UB802: 17 W UB502: 13 W Mains Voltage USA/Canada 120 V~, 60 Hz, MXUL5 adapter U.K./Australia 240 V~, 50 Hz, MXUK5 adapter Europe 230 V~, 50 Hz, MXEU5 adapter Japan 100 V~, 60 Hz, MXJP5 adapter Physical / Weight UB1202 Dimensions (H x W x D) approx. 47 x 220 x 242 mm (1 5/6 x 8 2/3 x 9 1/2") Weight (net) approx. 2.15 kg (4.73 lbs) UB1002 Dimensions (H x W x D) approx.
We Hear You