Instructions / Assembly
Fountain
Fuente
Fountain Top
Tapa de la Fuente
Bird
Pájaro
MODEL: 7292810
BEARS AROUND THE BIRCH TREE
NOTES:
Choose an appropriate location for your fountain.
While Beckett’s fountains are designed to operate as
splash free as possible, some water splashing out of the
fountain is inevitable. Place your fountain in a location
where any splashing will not cause damage.
Keep your fountain full of water and clear of dirt to ensure
proper functioning of the pump.
NOTAS:
Escoja un lugar apropiado para su fuente.
Aunque las fuentes de Beckett están diseñadas para
operar sin que salpique el agua, va a ser inevitable que el
agua salpique un poco alrededor de la fuente. Ponga su
fuente en un lugar que no cause daños si el agua salpica.
Mantenga su fuente llena de agua y limpia de residuos y
mugre para asegurar un adecuado funcionamiento de la
bomba.
STEP 1: Place the Fountain on a level, water tolerant surface, away from falling leaves.
PASO 1: Coloque el Fuente en un riegue la superficie tolerante, lejos de caerse hojas.
STEP 2: Set the pump’s flow control to max. Place the Pump in the center of the Basin.
PASO 2: Fije el flujo del agua de la Bomba al Máximo. Coloque la bomba en el centro de la base.
STEP 3: Feed the electrical Cord down through the Basin's Center Pipe and route the Cord out through the Cord Exit
Notch.
PASO 3: Pase el Cables Eléctrico a través del Tubo Central del base y guíelo a través de la Muesca de Salida.
STEP 4: Attach the discharge tubing to pump’s discharge. Position the Fountain Top onto the Basin.
PASO 4: Conecte el tubo de descarga de la bomba de descarga. Con mucho cuidado, posicione la Tapa de la Fuente
en la Base.
STEP 5: Position the Bird onto the Fountain.
PASO 5: Posicione la Tapa de la Fuente en la Base.
STEP 6: Fill the Basin with water. Do not allow the Pump to run dry!
PASO 6: Llene el Base de agua. ¡No permita que la Bomba funcione seca!
STEP 7: Attach the light cord to the transformer, Plug the transformer and pump electrical cord into a properly grounded
GFCI outlet.
PASO 7: Conecte el cable de luz al transformador, Enchufe el transformador y la bomba de cable eléctrico en un
tomacorriente GFCI de tierra adecuada.
STEP 8: To adjust the Fountain’s flow rate, unplug the Pump electrical cord from the outlet and adjust the Pump’s flow
control. Repeat above steps until you achieve the desired flow.
PASO 8: Si decide ajustar el flujo del agua en la fuente, desconecte el cordón eléctrico de la Bomba, y ajuste el control
del agua en la Bomba hasta lograr el flujo deseado.
INSTRUCTIONS
INSTRUCCIONES