User's Manual

BEC AC867 SE
BEC AC867 EX
QUICK INSTALL GUIDE
RidgeWave® 5GHz Subscriber Unit

 

 
BEC AC867 SE
BEC AV867 EX
QUICK INSTALL GUIDE
RidgeWave® 5GHz Subscriber Unit
PoE Adapter
AP/Bridge
Power Cord
Detachable Antennas
BEC AC867EX: 2x 5GHz Antennas
BEC AC867EX
Quick Install Guide
Pole Mounting
Strap
Wall Mount
Screw Set
CONTACT US
v1.0
For 24/7 BEC Support Portal: https://bectechnologies.net/support/
For Other Inquiries : [e-mail]
BEC Technologies. Inc. | 3301 Matrix Drive Ste 200. Richardson, TX 75082 USA
TEL : [phone] | FAX : [phone]
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 25cm between the radiator & your body.
1. Installation personal
This product is designed for specic application and needs to be
installed by a qualied personal who has RF and related rule
knowledge. The general user shall not attempt to install or change
the setting.
2. Installation location
The product shall be installed at a location where the radiating
antenna can be kept 25cm from nearby person in normal operation
condition to meet regulatory RF exposure requirement.
3. External antenna
Use only the antennas which have been approved by the applicant.
The non-approved antenna(s) may produce unwanted spurious or
excessive RF transmitting power which may lead to the violation of
FCC limit and is prohibited.
4. Installation procedure
Please refer to user’s manual for the detail.
5. Warning
Please carefully select the installation position and make sure that
the nal output power does not exceed the limit set force in
relevant rules. The violation of the rule could lead to serious federal
penalty.
Maximum data rates are based on IEEE802.11 standards. Actual throughput and range
may vary depending on many factors including environmental conditions, distance
between devices, radio interference in the operating environment and mix of devices in
the network. Features and specications are subject to change without notice.
Copyright@ 2019 BEC Technologies Inc. All rights reserved.
FCC STATEMENT
PROFESSIONAL INSTALLATION INSTRUCTION