Users Manual Part 1

Device Configuration

Interface Setup – Wireless 2.4GHz

BEC 4700A / 4700AZ User Manual

 Security Type - WEP

WEP Authentication Method: WEP authentication method, there are two methods of authentication

used, Open System authentication (OPENWEB) and Share Key authentication (SHAREDWEB). We

suggest you select OPENWEB.

Key 1 to Key 4: Enter the key to encrypt wireless data. To allow encrypted data transmission, the

WEP Encryption Key values on all wireless stations must be the same as the router. There are four

keys for your selection. The input format is in HEX style, 5 and 13 HEX codes are required for 64-

bitWEP and 128-bitWEP respectively.

If you chose WEP 64-bit, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9", "A-

F").

If you chose WEP 128-bit, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9", "A-

F").

You must configure all four keys, but only one key can be activated at any one time. The default key

is key 1.

NOTE: When you enable WPS function, this WEP function will be

invalid. And if you select one of WEP-64Bits/ WEP-128Bits, the

following prompt box will appear to notice you.

 Security Type - WPA-PSK / WPA2-PSK / Mixed WPA & WPA2

WPA Algorithms: TKIP (Temporal Key Integrity Protocol) or AES (Advanced Encryption System)

utilizes a stronger encryption method and incorporates Message Integrity Code (MIC) to provide

protection against hackers.

Pre-Shared key: The key for network authentication. The input format should be 8-63 ASCII

characters or 64 hexadecimal characters

Key Renewal Interval: The time interval for changing the security key automatically between wireless

client and AP.