Quick Start Guide

BeBop Sensors Forte Data Glove QuickStart Guide

The data glove is a high-performance augmented reality and virtual reality controller that can

communicate over USB or Bluetooth. This guide is meant to help you get started with the data

glove Unity SDK as quickly as possible.

How to Wear and Operate the Glove:

In order to get the best performance from the glove, it's important to make sure the glove is

worn properly - this means 1. your palm passes underneath the haptic strap, 2. your thumb

passes through the thumb loop and 3. the glove is firmly secured with the wrist strap and

your fingers are properly seated in the finger caps.

Note: Break in Period:

While your glove should perform accurately from the first time you put it on, note that each

glove has a wear in period of about 5 - 10 hours and will become more comfortable with

subsequent use.

To Turn On the Glove:

Press the power button once. After a short startup sequence, a

green LED should confirm that the glove is powered on and

waiting to be connected.

To Turn Off the Glove:

Push the Power Button on the back plate of the glove for

approximately 2.5 seconds. The LED should turn off to

indicate that the glove has powered down.

Charging the Glove:

Plug in a powered USB-C cable to the port in the back plate.

Calibrating the Glove:

The glove may require occasional recalibration. The full calibration process is done through the

provided software.

PAGE 1
BeBop Sensors Forte Data Glove QuickStart Guide The data glove is a high-performance augmented reality and virtual reality controller that can communicate over USB or Bluetooth. This guide is meant to help you get started with the data glove Unity SDK as quickly as possible. How to Wear and Operate the Glove: In order to get the best performance from the glove, it's important to make sure the glove is worn properly - this means 1. your palm passes underneath the haptic strap, 2.
PAGE 2
Frequently Asked Questions / Troubleshooting How do I contact support? If you have any problems, please email support@bebopsensors.com. Where’s the full documentation? Check out our full API documentation here: https://bebopsensors.com/api/data-glove/ Why is the hand model not responding? If the hand object isn't responding to the Data Glove, first check to make sure that the glove is powered on. If it is, try power-cycling the glove and restarting the program.