User's Manual

ManualsBrandsBearExtender ManualsElectronicsBearExtender Outdoor with WIFI

Windows Setup Guide

Step 1: Install Software

Insert the CD-ROM into your computer.

When the Autorun menu appears, select your version of Windows.

If the Autorun menu does not appear, navigate to your CD drive,

then right-click it and select “Open.”

Then double click the Setup program to begin.

Once the software has installed, connect BearExtender’s USB cable

directly to your computer. A popup will appear in the bottom right

corner of your screen. A second popup will conrm that the

installation has completed.

Do not connect BearExtender’s USB cable

If you have already connected it, please disconnect it.

It may take up to 30 seconds for the Autorun menu to

appear, depending on the speed of your CD drive.

Summary of content (6 pages)

PAGE 1
Windows Setup Guide Step 1: Install Software Do not connect BearExtender’s USB cable If you have already connected it, please disconnect it. Insert the CD-ROM into your computer. When the Autorun menu appears, select your version of Windows. It may take up to 30 seconds for the Autorun menu to appear, depending on the speed of your CD drive. If the Autorun menu does not appear, navigate to your CD drive, then right-click it and select “Open.” Then double click the Setup program to begin.
PAGE 2
Step 2: Disable your Built-in Wi-Fi card If your computer has a built-in Wi-Fi card, please disable it. Some laptops have a ON/OFF switch for disabling the built-in Wi-Fi card. If your computer does not have a switch, go to Control Panel > Network and Sharing > “Change Adapter Settings”. Then right-click your built-in Wi-Fi card and click “Disable.” You can repeat this step and select “Enable” when you wish to use your internal Wi-Fi card again.
PAGE 3
If you are unable to locate the Network icon, follow these steps: 1. Go to Control Panel 2. Click “Network and Sharing Center” 3. Click “Change adapter settings” 4. Then right-click “802.11n Wi-Fi adapter” or “Wireless Connection 2” and select “Connect/Disconnect” The digit after "Wireless Network Connection” may vary if you have previously had other Wi-Fi adapters installed on your computer. Congratulations You have finished setting up BearExtender.
PAGE 4
Troubleshooting 1. I do not see any connection icon in the bottom right of my screen, and when I follow the instructions to go to the device in the Network and Sharing center I am not able to see the device there either. Be sure you have run the Setup program from the CD in its entirety. If you have, and BearExtender is connected to your computer, please contact BearExtender support for further assistance. 2.
PAGE 5
If you have confirmed your internal network card is disabled, the other possibility is there may not be any other Wi-Fi networks in range. Unlike 3G/cellular data service, which you have to pay for, WiFi does not have a monthly service fee but you do need to be within range of a wireless network in order to use it.
PAGE 6
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.