BEAUTIFUL CARD CORPORATION User manual of One Wallet Version 1.
1. Introduction of One Wallet “One Wallet” is a wearable payment device, user can add multi credit cards into “one wallet”. Here are the steps for operation of “one wallet”. 1.1 Battery charging 1.2 Install the apps into mobile phone. 1.3 Connect the mobile phone with “one wallet”. 1.4 Enroll the fingerprinter of user into “one wallet”. 1.5 Add credit card into “one wallet” by loading applets. 1.6 Payment operation of “one wallet”.
2. Appearance: 2.
2.2 Battery Charging: Connect to the USB port for battery charging through an usb socket.
3. Fingerprinter function There are three modes for fingerprinter function: The fingerprinter function of One Wallet includes three modes, 3.1 Verification mode: To verify if the fingerprinter data matched? There are two situations need to verify the fingerprinter. ⚫ Enter the operation of the One wallet. ⚫ Wallet holder verification for Payment. 3.2 Enroll mode: To enroll the fingerprinter, and the enrollment capacity is five fingers.
3.
3.
3.
4. Bluetooth connection 4.1 There are three actions needs to be done sequentially before enable the Bluetooth connection function of One Wallet, ⚫ The one wallet is in “Power off” mode ⚫ Put the one wallet into the usb charger ⚫ Verify the fingerprinter 4.2 Minimum system requirements: OS: Android 8.0/iOS 12 BLE 4.2 5. RF Exposure warning The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment.
5. Payment operation of One Wallet Step#1: Power on Press either button Step#2: Fingerprinter verification Pass Step#3: Select card Press “UP”/”Down” button to scroll the card list; Stop at what you want and wait for 5 seconds to select it.
Step#4: Consumer Device wallet holder Verification Method Confirm the selected card by fingerprinter verification. Step#5: Enable the Card mode of NFC function for transaction Press either button to enable the NFC function for transaction(20 seconds timeout).
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any change or modification not expressly approved by Beautifulcard Corp. may void the user's authority to operate the equipment.