User's Guide

BACK P
AGE
FRONT PAGE
SIM
SAM
SAM
SD
F
ig.6 - Charging Cradle Bottom View
USB-
C
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
RF Exposure Information (FCC SAR) :
This device meets the government's requirements for exposure to radio waves. This device is designed
and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. *Tests for SAR are conducted using
standard operating positions accepted by the FCC with the device transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the poser required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower the power
output.
The highest SAR value for the device as reported to the FCC when worn on the body, as described in this
user guide, is 1.495W/kg (Body-worn measurements differ among devices, depending upon available
enhancements and FCC requirements.) While there may be differences between the SAR levels of various
devices and at various positions, they all meet the government requirement. The FCC has granted an
Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found
under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID: 2AB7X-
WISEPOSEPLUS.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use
with an accessory that contains no metal and the positions the device a minimum of mm from the
body . Use of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you
do not use a body-worn accessory position the device a minimum of mm from your body when the
device is switched on at its highest certified power level in all tested frequency bands.
For handheld operating condition, SAR meets with FCC limit 4.0W/kg.
RF Exposure Information (IC SAR) :
This device meets the government's requirements for exposure to radio waves. This device is designed
and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
Innovation, Science and Economic Development Canada licence-exempt RSS standard(s).
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the IC is 1.6 W/kg. *Tests for SAR are conducted using
standard operating positions accepted by the IC with the device transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the poser required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower the power
output.
The highest SAR value for the device as reported to the IC when worn on the body, as described in this
user guide, is 1.495W/kg (Body-worn measurements differ among devices, depending upon available
enhancements and IC requirements.) While there may be differences between the SAR levels of various
devices and at various positions, they all meet the government requirement. The IC has granted an
Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the
IC RF exposure guidelines. SAR information on this device is the
IC : 24228-WPOSEPLUS.
For body worn operation, this device has been tested and meets the IC RF exposure guidelines for use
with an accessory that contains no metal and the positions the device a minimum of 10 mm from the
body . Use of other enhancements may not ensure compliance with IC RF exposure guidelines. If you do
not use a body-worn accessory position the device a minimum of 10 mm from your body when the device
is switched on at its highest certified power level in all tested frequency bands.
For handheld operating condition, SAR meets with IC limit 4.0W/kg.
10
10
Informations sur l'exposition aux RF (IC SAR):
Cet appareil répond aux exigences du gouvernement en matière d'exposition aux ondes radio. Cet appareil est conçu et fabriqué pour ne pas
dépasser les limites d'émission pour l'exposition à l'énergie de radiofréquence (RF) définies par Innovation, Sciences et Développement
économique Canada norme (s) RSS sans licence.
La norme d'exposition pour les appareils sans fil utilise une unité de mesure connue sous le nom de débit d'absorption spécifique ou DAS. La limite
SAR définie par l'IC est de 1,6 W / kg. * Les tests de DAS sont effectués en utilisant des positions de fonctionnement standard acceptées par l'IC avec
l'appareil émettant à son niveau de puissance certifié le plus élevé dans toutes les bandes de fréquences testées. Bien que le DAS soit
déterminé à la puissance certifiée la plus élevée niveau, le niveau SAR réel de l'appareil pendant son fonctionnement peut être bien inférieur
à la valeur maximale. En effet, l'appareil est con
çu pour fonctionner à plusieurs niveaux de puissance de manière à n'utiliser que le poseur requis
pour atteindre le réseau. En général, plus vous êtes proche d'une antenne de station de base sans fil, plus la puissance de sortie est faible.
La valeur DAS la plus élevée pour l'appareil telle que rapportée à l'IC lorsqu'il est porté sur le corps, comme décrit dans ce guide de l'utilisateur,
est de 1,495 W / kg (les mesures portées sur le corps diffèrent selon les appareils, selon améliorations et exigences IC.) Bien qu'il puisse y avoir des
différences entre les niveaux de DAS de divers appareils et à diverses positions, ils satisfont tous aux exigences gouvernementales. Le CI a accordé un
Autorisation d'équipement pour cet appareil avec tous les niveaux de DAS signalés évalués comme étant conformes aux directives d'exposition
aux RF d'IC. Les informations SAR sur cet appareil sont les IC: 24228-WPOSEPLUS.
Pour une utilisation sur le corps, cet appareil a été testé et répond aux directives d'exposition RF IC pour une utilisation avec un accessoire qui ne
contient pas de métal et les positions de l'appareil à un minimum de 10 mm du corps. L'utilisation d'autres améliorations peut ne pas garantir la
conformité aux directives d'exposition RF IC. Si vous n'utilisez pas d'accessoire porté sur le corps, placez l'appareil à au moins 10 mm de votre corps
lorsque l'appareil est allumé à son niveau de puissance certifié le plus élevé dans toutes les bandes de fréquences testées.
Pour les conditions de fonctionnement portable, le DAS est conforme à la limite IC de 4,0 W / kg.