Page Revision Date Wisepad User Guide 1 of 12 1.
Page Revision Date Switch on Wisepad. Standby can be seen on LCD. Then press the Bluetooth button on red circle on figure shown, blue light is flashing. That means the Bluetooth module is ready to be paired. 2 of 12 1.
Page Revision Date 3 of 12 1.
Page Revision Date 2. Open the App for using wisepad, and press the selection key on the bottom, there are 4 options could be seen. Upper left corner: Scan Bluetooth Upper right corner: Paired Device Lower left corner: Stop Bluetooth Lower right corner: Unpair All Press Scan Bluetooth to connect Wisepad 4 of 12 1.
Page Revision Date 3 After connected Bluetooth, Bluetooth connected and MAC Address will be displayed on the APP, and Wisepad Ready will be shown on LCD. Blue light LED will keep on. 5 of 12 1.
Page Revision Date Upper left corner Get Device info Middle left: Check Card Lower left corner: Set Amount Upper right corner: Clear Log Middle right: Cancel Check Card Lower right corner: Start EMV 1. Wisepad info and status could be get after press Get Device info. The display log can be cleared by pressing Clear log. 6 of 12 1.
Page Revision Date 2. User can perform swipe card or insert ICC card after press Check Card button 7 of 12 1.
Page Revision Date 2.1 The following example is after a successful swipe card 8 of 12 1.
Page Revision Date 2.2 Further details could be checked with sliding middle log. 9 of 12 1.
Page Revision Date 2.3 ICC Card Inserted will be shown after inserted an ICC card successfully 10 of 12 1.
Page Revision Date 11 of 12 1.0 17Mar2014 3. User could perform a simulated EMV transaction after press Start EMV.. 4. Press Disconnect Bluetooth to disconnect the device, and Bluetooth disconnected will be shown. Wisepad will reset to Standby.
Page Revision Date 12 of 12 1.0 17Mar2014 FCC Requirement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.