BLIMS 9100 Руководство по эксплуатации и техобслуживанию
IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER Indicates a hazardous situation which, if not avoided, will cause serious injury.
- Do not touch the appliance with any wet part of the body and do not operate it when barefoot. - This appliance is designed solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms). The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls.
- Overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat and oil. - Never leave the appliance unattended during food drying. - If alcoholic beverages are used when cooking foods (e.g. rum, cognac, wine), remember that alcohol evaporates at high temperatures. As a result, there is a risk that vapours released by the alcohol may catch fire upon coming into contact with the electrical heating element. - Never use steam cleaning equipment.
2. Lift the handle up as shown in Fig. 2 Fig. 1 Fig. 2 PREPARING THE HOUSING UNIT • • • • Kitchen units in contact with the oven must be heat resistant (min 90°C). Carry out all cabinet cutting work before fitting the oven in the housing and carefully remove all wood chips and sawdust. After installation, the bottom of the oven must no longer be accessible. For correct appliance operation, do not obstruct the minimum gap between the worktop and the upper edge of the oven.
- Make sure that the electrical cables of other appliances do not touch hot parts of the oven or become trapped in the door. Do not expose the oven to atmospheric agents. Never pour water on the induction plate when inserted into the oven or when it is hot; this could damage the glass or the enamel coating. Insert and remove the induction plate carefully in order to avoid accidental damage to the glass and/ or electrical plug.
TROUBLESHOOTING GUIDE The oven does not work: • • Check for the presence of mains electrical power and if the oven is connected to the electrical supply. Turn off the oven and restart it to see if the fault persists. The electronic programmer does not work: • If the display shows the letter “ ” followed by a number, contact your nearest After-sales Service. Specify in this case the number that follows the letter “ ”.
N.B.: during prolonged cooking of foods with a high water content (e.g. pizza, vegetables, etc.) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories: • • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. Food residues can be easily removed using a brush or sponge.
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY) 1. 2. 3. Remove the side accessory holder grilles (Fig. 4). Pull the heating element out a little (Fig. 5) and lower it (Fig. 6). To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral supports. Fig. 4 Fig. 5 Fig. 6 REPLACING THE OVEN LAMP To replace the rear lamp (if present): 1. Disconnect the oven from the power supply. 2. Unscrew the lamp cover (Fig.
INSTRUCTIONS FOR OVEN USE FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION The induction oven is equipped with an electrical socket on the rear wall of the oven to supply power to the heating element inside the induction plate when plugged in. The induction plate is designed to work together with the induction cooking vessel supplied with the oven. Improved cooking performances and energy consumption can be achieved by using the cooking vessel and induction plate. 1. Control panel 2.
F. COOKING VESSEL: the cooking vessel is designed to be used with the induction plate and should be placed according to the position markings on the induction plate glass. G. INDUCTION PLATE: to be used in induction mode only by placing it on the third shelf position and ensuring the electrical plug is fully inserted (refer to "Inserting wire shelves and other accessories in the oven"). The number of accessories may vary according to which model is purchased.
Fig. 4 1. 2. Fig. 5 Use both hands to place the cooking vessel on the induction plate (Fig. 4). Place the cooking vessel at the centre of the markings on the glass (Fig. 5). REMOVAL OF THE COOKING VESSEL AND INDUCTION PLATE REMOVING THE COOKING VESSEL: IMPORTANT: The induction cooking vessel can become extremely hot. Always use oven gloves to touch and move it. Fig. 1 Fig. 2 1. Using both hands, grasp the front handle and partially remove the cooking vessel (Fig. 1). 2.
to return to the previous screen to browse the functions/options and change pre-set values to select and confirm settings to start cooking LIST OF FUNCTIONS After switching on the oven, press the symbol and the display will show the following indication. Press any key to skip the message. NOTE: The induction first alert can be disabled/enabled through the Settings Menu. If the induction plate is already properly engaged, when oven is switched on, the induction first alert will not be shown.
SELECTING COOKING FUNCTIONS 1. 2. If the oven is off press button ; the display will show the cooking functions. To browse the various possibilities, press buttons : the selectable function is highlighted in white in the centre of the screen. N.B.: for the list and description of functions, see the specific table at page 18 and at page 23.
4. To confirm your choice, press button . Note: in induction mode, preheating is not required. Induction mode requires all cooking operations to have a cold start. FAST PREHEATING (Standard Functions Only) 180°C - 00:02 180°C - 00:02 180°C TEMPERATURE INSERT IN TEMPERATURE INSERT IN TEMPERATURE Fast Preheating - 00:02 Preheating INSERT IN Oven is Hot! If you wish to preheat the oven quickly before inserting food, change the oven’s default selection as follows: 1.
SETTING END OF COOKING TIME/DELAYED START The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and 59 minutes. This can only be done once cooking time has been set. This setting is only possible when pre-heating is not required for the selected function.
Cooking nearly finished Please check on food Please turn food Cooking Finished at 19:45 Press to Prolong Cooking N.B.: Some dishes must be turned or stirred half way through cooking: the oven will emit an acoustic signal and the display will indicate what action is required. The initial cooking time displayed is merely for guidance: it can be prolonged automatically during cooking. Shortly before cooking time finishes, the oven prompts you to check that the food is cooked to your satisfaction.
--:-- 180°C TEMPERATURE No 150°C COOK TIME Conventional PREHEAT --:-END TIME 100°C TEMPERATURE Insert Meat Probe or press OK MEAT PROBE Conventional INDUCTION FUNCTIONS Thanks to the Induction Heating technology, the oven offers several cooking functions (see Function Description table) which guarantee high cooking performances together with a very fast cooking process and low energy consumption.
FUNCTION DESCRIPTION TABLE MAIN MENU SETTINGS RECIPES MEAT PROBE RECIPES TRADITIONAL SPECIALS INDUCTION FUNCTIONS Setting the display (language, time, brightness, volume of acoustic signal, energy saving function). Selecting 30 different pre-set recipes (see enclosed recipe booklet). The oven automatically sets the optimum cooking temperature, function and time. It is important to follow the instructions given in the recipe book regarding preparation, accessories and which oven shelf to use.
SPECIALS DEFROST KEEP WARM RISING CONVENIENCE MAXI COOKING To speed up defrosting of food. Place food on the middle shelf. Leave food in its packaging in order to prevent it from drying out on the outside. For keeping just-cooked food hot and crisp (e.g: meat, fried food or flans). Place food on the middle shelf. The function will not activate if the temperature in the oven is above 65°C. For optimal rising of sweet or savoury dough.
INDUCTION FUNCTIONS The function automatically selects the ideal Roast beef 4 steps: from 0.6 to 2 kg cooking temperature and mode for different weight categories (see oven display). It is Roast meat possible to roast any type of meat (e.g. beef, 3 steps: from 1 to 4 kg veal, pork, ribs, lamb, etc.). The function "top finishing" is optimal to obtain high level of fillet / piece surface browning The function automatically selects the ideal Whole 5 steps: from 0.
Low grill Top Finishing Medium grill High grill FINISHING Low power Base Finishing Medium power High power Recipe with cooking vessel (provided) Lasagna Pasta pasticciata/ cannelloni Roast beef rare 48° (0.6 - 0.8 Kg) Roast beef rare 48° (0.9 - 1.2 Kg) Roast beef rare 48° (1.3 - 1.5 Kg) Roast beef rare 48° (1.6 - 2 Kg) Roast pork / veal (1 - 2 Kg) Roast pork / veal (2 - 3 Kg) Roast pork / veal (3 - 4 Kg) Pork ribs Roast chicken (0.6 - 0.8 Kg) Roast chicken (0.9 - 1.2 Kg) Roast chicken (1.3 - 1.
Recipe with cooking vessel (provided) Function Fish fillet / piece Preheat Level tray Temperature 3 3 3 3 3 3 3 3 Automatic Automatic Automatic Automatic Automatic Automatic Automatic Automatic 3 3 3 3 Automatic Automatic Automatic Automatic Cod fish Roasted potatoes Mixed vegetables Stuffed zucchini Stuffed tomatoes Small cakes Biscuit / Sablè Fruit tart Cookies – muffins Cookies Pastry cakes No No No No No No No No Quiche Lorraine Traditional bread Homestyle pizza Crisp pizza Salty cakes Brea
COOKING TABLE Recipe Function Pre- Shelf (from heating bottom) Temp.
Recipe Savoury pies (vegetable pie, quiche lorraine) Vols-au-vent / Puff pastry savouries Lasagna / Baked pasta / Cannelloni / Flans Lamb / Veal / Beef / Pork 1 Kg Chicken / Rabbit / Duck 1 Kg Turkey / Goose 3 Kg Baked fish / en papillote (fillet, whole) Stuffed vegetables (tomatoes, courgettes, aubergines) Toast Function Pre- Shelf (from heating bottom) Temp.
Recipe Function Pre- Shelf (from heating bottom) Temp.
TESTED RECIPES in compliance with IEC 50304/60350:2009-03 and DIN 3360-12:07:07 Recipe Function Pre- Shelf (from Temp. Time Accessories and notes heating bottom) (°C) (min) IEC 60350:2009-03 § 8.4.
RECOMMENDED USE AND TIPS How to read the cooking table The table indicates the best function to use for any given food, to be cooked on one or more shelves at the same time. Cooking times start from the moment food is placed in the oven, excluding pre-heating (where required). Cooking temperatures and times are purely for guidance and will depend on the amount of food and type of accessory used.
- - - When using the roast Meat and whole roast Chicken functions, the meat does not need to be turned over. For the “Roast beef” function: after cooking for 15 minutes it is recommended that the meat is turned to achieve even surface browning. When the beef is cooked to your liking take it out of the oven and leave to rest.
Printed in Italy 09/2012 5019 400 00454 RU Copyright Whirlpool Europe s.r.l. 2010. All rights reserved Bauknecht, Polar and Ignis are registered trademarks of the Whirlpool group of companies. http://www.bauknecht.
