Gemstone Range User Manual Onyx Granite Diamond
MODEL:- ONYX □ GRANITE □ DIAMOND □ SERIAL NUMBER:- PURCHASE DATE:- / DAY / MONTH YEAR IMPORTANT PLEASE READ THIS MANUAL FULLY PRIOR TO ASSEMBLY AND USE For your safety and to ensure a long and trouble free life of your bicycle, check the operation of brakes, lights, tyre pressures, horn and gears. Also check all fasteners, including quick release mechanisms, before every ride.
Thank you for purchasing a BATRIBIKE Electric Bicycle from Fallowgate Limited. With care and correct usage your bicycle will give many years of service. Please read the manual fully before use. Important PLEASE CHARGE THE BATTERY BEFORE FIRST USING THE BICYCLE. Even though the battery indicator will show charge this cannot be relied upon until the battery has had the initial full charge.
STEP 1 - Unpacking Please allow adequate space for building the bicycle. You can use the flattened box as a working area. TAKE CARE—Removal of the bicycle from the box may require the assistance of another person. For the Granite and Diamond models the stand should be extended and the bicycle placed on the floor for stability ready for building. The bicycle is protected by bubble-wrap and may be tied or tie-wrapped. Please remove all packing material carefully and check the box for loose parts.
tighten fully or is still loose after locking then the clamping pressure can be adjusted by the knurled nut. The clamp should be tight as it fits against the frame. Fit the seat and adjust for height with the locking clamp. Adjust for clamping pressure as necessary in the same manner as the main frame clamp. Fit the pedals. Remember that the right hand pedal has a standard thread but the left hand pedal has a reverse thread and must be tightened in the opposite direction. A 15 mm spanner will be required.
STEP 3 - Battery Charging .Battery Charging. The battery can be either charged on or off the bicycle but must be charged inside in dry conditions to avoid the risk of electrical shock. Only use the charger supplied with the bicycle. 1) 2) 3) Lift handle on battery Ensure the power is turned off on the battery Insert charger lead into socket on battery casing taking note of the position of locating lug. 4) Insert 3 pin mains plug into mains socket & switch on at wall.
to travel then twist the throttle. After the throttle is used you can stop pedalling and the motor speed will be maintained. Obviously, if the bicycle is used under throttle only without pedal assist then the range will be substantially reduced. The Gemstone Range is provided with 6 speed Shimano gears. To change gear you can twist the handlebar mounted twist grip selector whilst pedalling. Gear number 1 is low for hills and rough terrain and gear 6 is high for normal road use.
Warranty Please retain your receipt as this is your proof of purchase and entitlement to Warranty. • The Frame of your new BATRIBIKE Gemstone Range is guaranteed for 2 years from date of purchase.