Instructions / Assembly

1
Tecma Bathroom Anywhere™
Owner’s and Installation Manual
Installation
Form No. 38792 Rev. D 09/22/10
www.bathroomanywhere.com
PRODUCT INFORMATION
Register this product at www.bathroomanywhere.com
Date of Purchase:
Model Serial #:
Please keep this manual for future reference.
Caution: To avoid damaging property and to
make sure the unit operates correctly, please do the
following:
!
Do not fl ush anything other than human organic waste ■
and toilet tissue. Do not fl ush paper towels, pre-moistened
wipes, condoms, feminine hygiene products, dental fl oss or
household garbage.
Do not allow the Bathroom Anywhere system to freeze. See ■
Winterization.
Make sure that any pipe work that may be exposed to freez- ■
ing temperatures is insulated.
Make sure that plumbing fi xtures attached to the pump do ■
not leak. If there is a power failure the pump will not oper-
ate, and this could cause the unit to overfl ow and fl ood.
Read ALL these instructions before installing the Tecma Bathroom Anywhere unit.
Warning! Read and understand the warnings
listed in this document before you install, operate, or service
this system. If you do not obey these warnings there is a
risk of property loss, injury, or electrocution. Do not make
any changes to this unit as this could result in property
damage, injury, or electrocution.
Thetford Corporation accepts no responsibility or liability
for damage to equipment, injury, or death that may result
from the system's improper installation, service, or opera-
tion.
Thetford Corporation recommends that plumbing and elec-
trical work be performed by a licensed tradesperson. Local
permit and code compliance is required.
Warranty
The pump must be connected to a properly grounded ■
(GFCI - ground fault circuit interrupter) receptacle on a
dedicated 15 AMP circuit.
Do not use in swimming pool or marine areas. ■
Always disconnect the plug from the power source before ■
servicing or handling the pump.
Do not use an extension cord with this unit! ■
Do not make any modifi cations to, or remove the ground ■
pin from, the pump's power supply cord plug.
Refer to the one-page warranty statement. ■
Record your product information. Keep for future reference. ■
Refer to Fig. B.
!
S
eri
a
l
Number
2
Location of Serial Number
Fig. B
ART00104
Required Tools
Pipe saw ■
Phillips screw driver ■
Flathead screw driver ■
5/16" Socket wrench ■
Hammer ■
Level ■
Tape Measure ■
Drill ■
1/2" masonry drill bit (Concrete fl oors) ■
1/4" drill bit (Wood fl oors) ■
Materials Not Provided
PVC/ABS primer and cement ■
1-1/4",1-1/2", and 2" rigid (Schedule 40) pipe fittings, as ■
needed
3" pipe extension and 3" coupler (depends on installation) ■
Tee-wye sewer connection ■
Ball valves sized to inlet and discharge pipe sizes ■
2" Sewage pump check valve (depends on installation) ■
For optimal performance, use long sweep 90° angles. Refer ■
to Fig. A.
*Long Sweep
Standard Elbow
Fig. A
Electrical Cautions:
To ensure safe operation:
CAUTION: Do NOT use one-way air admittance
valves (also known as cheater vents). Macerating
pumps need two-way air movement.
*Two connected 45° angles can be substituted for one long sweep
ART00180-1-3
Product Information
!