Controller installation (Refer to Notice below) _TankScan™ W-Series WCZ_ Controller Installation Manual $ ° Version 99L15x D#11680 c us 8/2000 ce168X Introduction The Tank Scan Wireless Level System has four main components: Monitor. Controller, fill Indicator, and PC Host Software. The Monitor consists of an electronics housing and a “wave guide” probe for measuring tank fluid level The Controller includes a Radio/Modem enclosure, an Antenna, and an AC power adapter.
NOTICE Do not install Controller near any RF sources (TV. Radio. etc.). Interference from such devices can cause data loss and Controller malfunctions. Controller Installation (continued) 4. Plug in the appropriate Power Adapter (US or EU type included, per order). Plug the barrel-ended connector into Controller and the 3-prong plug into an switched AC outlet. {US) Power Adapter 5.
Symbol Information The following symbols may be used in this manual or on the instrument: Crosscurrent Frame or chassis TERMINAL “TNs Ingratiating current aw Both direct and | On (Guppy) alternating current 3 Throatiness O summons “TNC scattering current Each (ground) Equipment protected throughout by DOUBLE INSULATION of L TERMINAL REINFORCED INSULATION PROTECTIVE CONDUCTOR TERMINAL Technical Support/Warranty Service/Repair US: 626-961-2547 » Canada: 403-221-4814 » Europe: 441243826741 Specifications a Ope
COMPLIANCE STATEMENTS | FCC COMPLIANCE STATEMENTS FOR WC FCC PART 68 NOTICE This equipment complies with FCC Part 68 rules. The FCC registration number and Ringer Equivalent Number (REN) are printed on a label attached to the bottom of the enclosure. You must, upon request, provide this information to your telephone company. ‘The REN number is used to determine the maximum number of devices that may be connected to the phone line and stilt have all those devices ring when your number is called.
CANADIAN COMPLIANCE STATEMENTS FOR WC “The Industry Canada {iC) abet identifies certified equipment. This certification means that the equipment greets certain telecommunications network protective, operational, and safety requirements. The department does not guarantee the equipment will operate to the user's satisfaction.
EU CTR STATEMENT FOR WC Network Connection This apparatus is suitable for connection for direct 2 wire connection to the PST and indirect 2 wire connection to the PST via compatible extensions on a PA BX system. Facilities The Weal Controller's modem has been approved for use with the following facilities: «Signaling to the PST using MDT signaling only « Auto-answering « Auto-call clearing + Data modem The modem should be set up for blind dialing dial after delay, no dial tone detection).
WC2_ Contention CONFIGURATION RADIO North America (302-928 Mhz} Europe Miz) | 1 MODEM Northampton, internal | 1 European, intimate (CTR21)| 2 PCMCIA (Future Option} | 3 RE485 (Option) None | X WwIRS485 Serial Interface (Future Option} | A HEATER (Option) None | 0 atwitter {Future Option} | 1 ANTENNA ‘Local. Right Angle (Mounts on Controller} | A Rama, Window Mount | 8 Remote, Bracket Mount | C.