Page 1 Lockable Anti-Theft Tablet Wall Mount Full Motion: Rotate, Fold, Swivel & Tilt For more information: barkanmounts.com T72VL-MAN-ONL-02_2011 If you are satisfied with the product, please give us a 5 stars rating on the website you bought it from. If you are not satisfied please contact us at https://www.barkanmounts.com/support and we will solve the problem for you. Tablet Size 7”-14” 17.7cm-35.5cm CAUTION This Mount is intended for use only with the maximum weight indicated.
ATTENTION! Please read the following. EN WARNING! Disregarding the safety and assembly instructions may result in the falling of, and/ or damage to your electrical appliance. Opening the package represents your undertaking to closely read and follow the instructions. This mount is not intended for use in public places. For Safety Instructions, warranty and further information, go to: www.barkanmounts.
UPOZORNĚNÍ! Nedodržení bezpečnostních a montážních pokynů, může způsobit pád a následné poškození Vašeho elektronického přístroje. Po rozbalení, si pozorně přečtěte montážní návod a ve vlastním zájmu jej dodržte. Tento držák není určeno pro použití na veřejných místech. Pro bezpečnostní pokyny a pro více informací se podívejte na: www.barkanmounts.
EN Caution This mount is intended for use only with the maximum weight as indicated. Using heavier products might cause injury. ES Atención Este soporte debe ser utilizado solo con el máximo peso especificado. Utilizarlo con productos de mayor peso puede causar daños. FR Attention Utilisez ce support en ne depassant pas le poids maximum indiqué. L’utilisation de produits plus lourds pourrait causer des dégats.
EN Do not install on walls and ceilings made of: gypsum board, drywall, light processed blocks, silicate boards/bricks, a damp wall, weak or very old blocks or wooden panel! For installation on gypsum or light processed blocks please consult with an authorized installer or appropriate building specialist to install the product. ES No instalar en paredes o techos de yeso, silicate, bloques viejos, paredes húmedas, paredes débiles o paneles de madera.
Page 2 Included Parts not to scale A Bracket + clamp B Z1 Screw Key x3 x2 Z2 Bolt Z4 Washer Z3 T-Nut x3 Z5 Anchor x3 x3 Z6 Allen key Z7 PVC pads x2 x3 Required Tools 7/16” 11 mm No. 2+3 5/16” 8 mm 1/8” 3 mm Max.1”\25mm 5/16” 8 mm
Page 3 1 Place the PVC pads inside the clamp holders Z7 x 2 2 Loosen the screw, open the ruler on the back according to your device size and tighten the screw. Example – for a device that is 10” to 11”, open the ruler to 10” 3 Installation on the underside of a cabinet.
Page 4 Mark the holes on the wall according to the desired height 5a 5b A A Use a Stud Finder Drill with 5/16” \ 8 mm drill bit Make sure all holes are drilled inside the studs 5/16” \ 8mm 2.75” \ 70mm Drill with 1/8” \ 3mm drill bit 1/8” \ 3mm Z5 2.75” \ 70mm The anchor must be sunk at least 3/8"/10 mm into the plaster coating Z4 Z1 Z4 FULL TIGHTENING Z1 FULL TIGHTENING
6 Page 5 Weight test Apply force on the upper part of the mount and make sure it is well connected 8 3Lbs/ 1.4Kg 7 Page 6 Installation on the underside of a cabinet Position the mount on the bottom of the cabinet and mark the holes according to the desired placement Drill with 5/16” \ 8mm drill bit 5/16” \ 8mm Z3 Weight test Apply force on the tablet clamp and make sure it is well connected Z4 Z2 3Lbs/ 1.
8 Page 6 Locking Unlock the clamp Open the clamp, relock it and take out the key 2 1 9 Close the clamp on your device Tilt adjustment 1. Remove the plastic cover. 2. Using the Allen key (Z6), tighten the screw in order to create the necessary friction for the tool free tilt mechanism. 3. Position the tablet at the desired tilt angle. 4. Return the plastic cover. 5. Rotate the tablet to the desired position. 2 360 ROTATION 5 3 1 10 TOUCH & TILT Maintenance 1. Remove the plastic cover. 2.