Page 1 Barkan TV Wall Mount Full Motion: Rotate, Swivel & Tilt TV Size 13”-65” 33cm-165cm TV Weight EU US 36kg 80lbs CAUTION This Mount is intended for use only with the maximum weight indicated. Using heavier products might cause injury. If you are satisfied with the product, please give us a 5 stars rating on the website you bought it from. If you are not satisfied please contact us at https://www.barkanmounts.com/support and we will solve the problem for you.
ATTENTION! Please read the following. EN WARNING! Disregarding the safety and assembly instructions may result in the falling of and/ or damage to your electrical appliance. Opening the package represents your undertaking to closely read and follow the instructions. This mount is not intended for use in public places. For Safety Instructions, warranty and further information, go to: www.barkanmounts.
SR UPOZORNĚNÍ! Nedodržení bezpečnostních a montážních pokynů, může způsobit pád a následné poškození Vašeho elektronického přístroje. Po rozbalení, si pozorně přečtěte montážní návod a ve vlastním zájmu jej dodržte. Tento držák není určeno pro použití na veřejných místech. Pro bezpečnostní pokyny a pro více informací se podívejte na: www.barkanmounts.
ES ! RU Caution - This mount is intended for use only with the maximum weight as indicated. Using heavier products might cause injury. Atención DA Attention EL Este soporte debe ser utilizado solo con el máximo peso especificado. Utilizarlo con productos de mayor peso puede causar daños. FR Utilisez ce support en ne depassant pas le poids maximum indiqué. L’utilisation de produits plus lourds pourrait causer des dégats.
EN ! Do not install on walls and ceilings made of: gypsum board, drywall, light processed blocks, silicate boards/bricks, a damp wall, weak or very old blocks or wooden panel! For installation on gypsum or light processed blocks please consult with an authorized installer or appropriate building specialist to install the product.
Page 2 Connect the TV plate to the back of the TV Wrong Right Purchase longer screws 100 – 400mm Continue according to your TV mounting holes pattern 75mm 1 Purchase Spacers Use them to adjust screws length inside the TV 1a 1a 1b Page 3 75x75 mm holes pattern Z3 NO FORCE Z1/Z2 Z4 B 2 Not Included Page 4
1b Page 3 Holes patterns 100x100 mm – 400x400 mm Connect the 4 adaptors to the TV Plate V3 FORCE B V1 B C V2 Position the Adaptors according to your TV’s hole pattern Max. 400mm 200mm TV 200mm 400mm 200mm Max.
Page 4 Install the Bracket on the Wall 2 3.6” / 9.2 cm Measure the distance between the location of the TV’s mounting holes’ center (marked on the Drilling Template) and the bottom of the TV, in order to set the required height of the TV 5.5” / 14cm https://www.barkanmounts.
4a Make sure all holes are inside the studs Page 5 4b First use ¼” \ 6mm drill 1/4” \ 6mm 1 2.75” \ 70mm Afterwards use 3/8” \ 10mm drill 2 3/8” \ 10mm 2.75” \ 70mm Drill with 1/4” \ 6mm drill 1/4” \ 6mm 2.75” \ 70mm Z7 3/8”/ 10 mm The anchor must be sunk at least 3/8"/10 mm into the plaster coating 1 Z6 Z6 2 A 2 x 360° A 1 2 7/16” 11 mm 7/16” 11 mm FULL TIGHTENING 4 x 360° FULL TIGHTENING
Page 6 Connect the TV with the TV Plate to the Bracket 5 Weight test - apply force on the upper part of the bracket and make sure it is well connected Place two nuts in the plastic nut-housings 6 Z5 80Lbs/ 36Kg 7 Place the bracket upright in order to connect the TV plate to the bracket. Make sure that the TV Plate slots are positioned properly on 2 small beams (Bracket) 8 In order to secure the TV, insert and tighten the screw from each side of the mount.
Page 7