Page 1 Adjustable Mount for Media Devices For more information: barkanmounts.com BM80-MAN-ONL-01_2008 If you are satisfied with the product, please give us a 5 stars rating on the website you bought it from. If you are not satisfied please contact us at https://www.barkanmounts.com/support and we will solve the problem for you. Wall 13.2 lbs Other 7.7 lbs 6 Kg 3.5 Kg CAUTION This Mount is intended for use only with the maximum weight indicated. Using heavier products might cause injury.
EN Caution This mount is intended for use only with the maximum weight as indicated. Using heavier products might cause injury. ES Atención Este soporte debe ser utilizado solo con el máximo peso especificado. Utilizarlo con productos de mayor peso puede causar daños. FR Attention Utilisez ce support en ne depassant pas le poids maximum indiqué. L’utilisation de produits plus lourds pourrait causer des dégats.
EN Do not install on walls and ceilings made of: gypsum board, drywall, light processed blocks, silicate boards/bricks, a damp wall, weak or very old blocks or wooden panel! For installation on gypsum or light processed blocks please consult with an authorized installer or appropriate building specialist to install the product. ES No instalar en paredes o techos de yeso, silicate, bloques viejos, paredes húmedas, paredes débiles o paneles de madera.
ATTENTION! Please read the following. EN WARNING! Disregarding the safety and assembly instructions may result in the falling of, and/ or damage to your electrical appliance. Opening the package represents your undertaking to closely read and follow the instructions. This mount is not intended for use in public places. For Safety Instructions, warranty and further information, go to: www.barkanmounts.
UPOZORNĚNÍ! Nedodržení bezpečnostních a montážních pokynů, může způsobit pád a následné poškození Vašeho elektronického přístroje. Po rozbalení, si pozorně přečtěte montážní návod a ve vlastním zájmu jej dodržte. Tento držák není určeno pro použití na veřejných místech. Pro bezpečnostní pokyny a pro více informací se podívejte na: www.barkanmounts.
Page 2 Included Parts not to scale A B Safety strap Clamp x1 x1 Z1 Z2 Anchor x1 x1 Z8 Sticker Z7 Washer Screw L inch 4 16 5 Z4 5 14 9 Z5 6 16 5 Z6 8 25 M Z3 Z9 Extension arm x4 x2 L mm # Required Tools 1/4” 6 mm No.
Adjust the clamp opening Page 3 Device thickness 0”-0.9” / 0-2.3cm Device thickness 0.9”-2.4” / 2.3-6cm Installation on a wall Device thickness 2.4”-3.
1a Page 4 Install according to your wall type 1 1b Make sure all holes are drilled inside the studs Use a 1/4” \ 6mm drill bit 1/4” \ 6mm 5/4” \ 30mm Z1 Z7 Z2 Z2+Z7 A A FULL TIGHTENING FULL TIGHTENING 3 3 Page 6 Page 6
2 Page 5 Connect the mount to the back of the screen Continue according to your TV mounting hole pattern 2a Hole pattern of 200 mm height: connect the 2 extension arms to the mount, then connect the mount to the back of the screen. 2b Hole pattern above 200 mm: connect the mount to the back of the screen using the hole in the center.
Page 6 3 Securing Media device Adjust the clamp to fit your media device and tighten the screw. 4 Securing the Media device (Optional) Fasten the strap around the Media device to secure it.