DATA 3300DLC R9001459 INSTALLATION MANUAL
BARCO PROJECTION SYSTEMS DATA 3300DLC R9001459 INSTALLATION MANUAL Date : 121098 Art. No.
Federal communication commission (FCC statement) This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Table of Contents i TABLE OF CONTENTS TABLE OF CONTENTS .............................................................................................................................................................................. i-1 INSTALLATION MODE ............................................................................................................................................................................. 1-1 Starting up the Installation Mode ............................................
Installation Mode 1 INSTALLATION MODE Starting up the Installation Mode Push the control disc up or down to highlight Installation and then press ENTER. ENTER continues to the Installation mode selection menu. EXIT returns to operational mode.
Installation Mode Convergence adjustment of the LCD panels. Every LCD panel has 6 adjustment screws. By turning these screws you change the relative position of the panels and converge the image. Always start with the adjustment of the green panel. When the green image is correctly focused, it will later on be used as the reference image to converge the red and blue image. Next alignments have to be done : You have to adjust the green panel until the indicated lines on the screen are focused (sharp lines).
Installation Mode Green focusing a. Insure all convergence screws are adjusted to a length of about 33 mm (1.3") between the two plates. b. Adjust the projection lens until optimal focus for point 1 is obtained. c. Turn screw 2 for optimal focus of the corresponding green line 2 on the screen. d. This alignment influences the other, so repeat if necessary steps b. and c. until points 1 and 2 are focused. e.
Installation Mode l. Due to interaction, turning on screw 4, 5 and 6 can influence the focus of the image. If necessary, repeat procedure from step b. . Red on green convergence. Push the control disc up or down to highlight Red on green and press ENTER to display the Red on green test pattern. Repeat the same procedure as for Blue on green lines but read red when blue is indicated. CONVERGENCE GREEN BLUE ON GREEN RED ON GREEN HATCH Select with or then to return.
Installation Mode How to shift the image : - First shift the image left or right until the correct horizontal position hole indication line is obtained. Turn clockwise to shift the image to the right, turn counter clockwise to shift to the left. Use the hand screw. - Shift the image up or down until the correct vertical position of the image is obtained. Turn clockwise to shift the image up, turn counter clockwise to shift down. Use the hand screw. Midposition of the adjustable lensholder.
Hardware Set Up 2 HARDWARE SET UP How to activate the password function? The password function can be hardware set with a DIP switch on the CPU module. To change the position of this DIP switch, it is necessary to open first the top cover. Gaining access to the DIP switch Power down the projector and unplug the power cord from the wall outlet. Turn both lock screws with a screwdriver or coin counter clockwise. Lift up and pivot the top cover.