Installation Guide

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

3/22/18

Lavatory

Widespread

Faucet

Tools Needed

• Adjustable Wrench • Slip Joint Pliers • Teflon Pipe Tape •

NOTE: Cushion the wrench or slip joint pliers with an old cloth to protect the finish of the fixture.

1. Turn off water supply and open faucet to relieve pressure and drain

line. Remove existing faucet.

2. Insert spout firmly through center hole in sink and secure firmly using

large brass washer and brass hex nut.

3. Temporarily remove O-ring retainer nut and O-ring. Gently push spout

tee onto the end of the spout shank and then screw it on until it stops.

NOTE: Do not over tighten as this may cause damage to the

O-ring seal which acts as a stop. Make sure that the tee outlets are

aligned at an angle (see drawing) which allow maximum clearance for

hose connections.

4. Unscrew, and remove escutcheons from top of faucet bodies; do not

remove flat washers. Screw locknuts down to the end of the threads.

Insert the faucet bodies up through the outside sink holes. Make sure

that the faucet with the red-coated handle stem is on the left (hot) side

and that the faucet with the blue-coated handle stem is on the right (cold) side.

5. Attach connecting hoses to the faucet bodies and spout tees. Hoses may

be flexed to fit within available space.

6. Place handle assemblies on faucet stems and turn to closed positions (hot

faucet clockwise, cold faucet counter clockwise).Reposition handle assemblies

on stems to correct positions and secure in place by tightening handle

assembly set (screwwith a provided allen-wrench). Install desired handles

into handle assemblies.

7. Connect water supply to the bodies and shut-off valve.

8. Open water shutoff valves and check for water leaks at all connections. Flush

the faucet thoroughly to remove any particles in water lines or faucets. To do

this, remove aerator and run hot and cold water through the faucet. Replace and

tighten aerator when finished.

NOTE: Please seek professional help if you have copper plumbing in your home.

Cleaning Instructions

Wipe this whole set off with warm water and a soft cloth. DO NOT use soaps, cleansers, or brass cleaners as they will

disintegrate the protective lacquer coating and leave the brass exposed causing it to tarnish.

PAGE 1
Lavatory Widespread Faucet INSTALLATION INSTRUCTIONS Tools Needed • Adjustable Wrench • Slip Joint Pliers • Teflon Pipe Tape • NOTE: Cushion the wrench or slip joint pliers with an old cloth to protect the finish of the fixture. 1. Turn off water supply and open faucet to relieve pressure and drain line. Remove existing faucet. 2. Insert spout firmly through center hole in sink and secure firmly using large brass washer and brass hex nut. 3. Temporarily remove O-ring retainer nut and O-ring.