Getting Started Guide

1/6 2/6

Tools

❑ DD 200 pro diamond core rig, vacuum base (P/N

on Hilti website: Item #3423950).

❑ Ø130mm crown

❑ 10-litre portable water supply tank (P/N on Hilti

website: Item #365595) + Extra portable Water Tank

❑ Vacuum Cleaner

❑ App Activation Tool on Android mobile phone

❑ RFID device (DOTR-900 from KCTNS) and selfie

stick

Materials

❑ Mortar Mapegrout SV

Sensor installation position

Installation step by step

U-Spot DUO installation

Getting started…

• Activation Tool installed on Android Smartphone (contact

support@urbiotica.com to get the latest version)

• Activation Tool username and password available

• Check that the network is configured in the Fastprk web platform

• Ensure that the LoRa coverage is ensured in the sensors’ installation area

1. Make a hole 75 mm deep with a crown of 130 mm Ø.

2. Clean and dry the hole from dust, debris and water.

3. Prepare the Mapegrout SV fast mortar.

4. For each of the sensors, fill the hole with enough mortar to ensure

that the mortar takes up all the space between the hole and the sensor

(approximately 250ml per sensor). For optimal installation, a surplus of

mortar must spill over the hole when the sensor is inserted

5. Clean the mortar that overflowed from the edge of the hole.

6. Place a weight over the sensor and wait until dries. We recommend

letting the mortar dry for 15 minutes.

• Sensor edge must be in line with the pavement

• Sensor should be completely flush within the

pavement

7. Take pictures of the installed sensors, about 70% - 80% of the

sensors.

8. Take a picture (if possible panoramic) to ensure there are no cars

nearby.

9. Activate the sensor with the Activation tool following the procedure

describe in the next pages.

PAGE 1
U-Spot DUO installation U-Spot DUO installation ! Getting started… Installation step by step • Activation Tool installed on Android Smartphone support@urbiotica.com to get the latest version) (contact 1. Make a hole 75 mm deep with a crown of 130 mm Ø. • Activation Tool username and password available • Check that the network is configured in the Fastprk web platform • Ensure that the LoRa coverage is ensured in the sensors’ installation area 2. Clean and dry the hole from dust, debris and water.
PAGE 2
U-Spot DUO activation U-Spot DUO activation U-Spot DUO sensor activation c) Once the sensor is physically installed, you can proceed with the activation using the RFID Tool and the Activation Tool App. Set up the App There are two ways of configuring the Activation app: one is manually (detailed steps below), or by importing a specific config file provided by Urbiotica. 1. Prepare the environment ❑ Make sure that the phone and RFID devices are fully charged.
PAGE 3
U-Spot DUO activation U-Spot DUO activation ❑ Option 2: Import a configuration file d) From the sidebar menu go to ‘Choose config file’ > ‘Browse file’, to load a specific configuration file, if required. Activate the sensor On each sensor, with the next order of actions, doing it from the top front of the sensor. This will power on and send the configuration previously selected to the sensor and synchronize it with the Fastprk platform.