User Manual

ManualsBrandsBanner ManualsRelayPresencePLUS P4 COLOR Series

Waterproof lens enclosure for use with sealed PresencePLUS sensors

(Lens enclosure shown mounted to camera)

• Rugged, waterproof housing, rated IEC IP68

• Available with 316 stainless steel or nickel-plated aluminum housing and

a choice of either acrylic or tempered optical glass windows

• Mounts directly to PresencePLUS® Sealed Pro and Sealed P4 models

(when ring light is not used)

For use with Length Model Housing Window

Replace window

model

PPROCAMS 50 mm

PPSLC50-G

Nickel-plated aluminum

Glass PPSLC-RG

PPSLC50-P Acrylic PPSLC-RP

PPROCAMS and P4.RS 75 mm

PPSLC75-G Glass PPSLC-RG

PPSLC75-P Acrylic PPSLC-RP

PPROCAMSS 50 mm

PPSSLC50-G

316 Stainless steel

Glass PPSLC-RG

PPSSLC50-P Acrylic PPSLC-RP

P4.RS 50 mm

P4SLC50-G

Nickel-plated aluminum

Glass PPSLC-RG

P4SLC50-P Acrylic PPSLC-RP

Specifications

Construction

Housing: Nickel-plated aluminum or 100% 316 stain-

less steel depending on model

Window: Acrylic or tempered optical glass, depending

on model

Outside Dimensions

PPSLC50-: 49.3 mm dia. by 48.9 mm long overall

(1.94" dia. x 1.93" long)

PPSLC75-: 49.3 mm dia. by 75 mm long overall (1.94"

dia x 2.95" long)

Environmental Rating

Nickel models: IEC IP68 when installed on Sealed Pre-

sencePLUS Sensors

Stainless steel models: NEMA 4X; IP68

Installing the Lens Enclosure

NOTE: Before installing this product, Banner Engineering Corp. recommends installing a light filter behind the

lens. The filter improves image quality by reducing unwanted ambient light.

1. Install and focus the lens.

2. Thread the lens enclosure onto the lens until the enclosure is seated against the sensor.

P.SLC..-.. Series Sealed Lens Enclosure

P/N 129252 Rev. C 11/28/2012

0 129252 7

Summary of content (2 pages)

PAGE 1
P.SLC..-.. Series Sealed Lens Enclosure Waterproof lens enclosure for use with sealed PresencePLUS sensors • Rugged, waterproof housing, rated IEC IP68 • Available with 316 stainless steel or nickel-plated aluminum housing and a choice of either acrylic or tempered optical glass windows • Mounts directly to PresencePLUS® Sealed Pro and Sealed P4 models (when ring light is not used) (Lens enclosure shown mounted to camera) For use with Length PPROCAMS 50 mm PPROCAMS and P4.
PAGE 2
P.SLC..-.. Series Sealed Lens Enclosure Banner Engineering Corp Limited Warranty Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned to the factory, is found to have been defective during the warranty period.