Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix L: Client: Model: Standards: ID’s: Report #: Manual Please refer to the following pages for the FHSS and DTS manuals. Banner Engineering Corporation RM912HP FCC 15.
Banner RM912HP Transceiver 1 Watt, 900 MHz FHSS Module User Manual Overview The Banner RM912HP device is a frequency hopping spread spectrum transceiver operating in the 902 – 928 MHz band. It is an implementation of a particular ISM band transceiver IC that includes an external LNA in the receive path and external 1 W power amplifier in the transmit path, as well as all necessary RF switches and matching components.
Power Control Users that wish to utilize the entire 1 W transmit capability of this radio must also ensure that they are using all 50 frequencies. Users that do not wish to use all 50 frequencies must then compensate by keeping the transmit power level below 250 mW, and still must use at least 25 frequencies. Contact the factory for details on adjusting RF power levels. Operation Operational details for the radio appear in the PowerPoint document “RM912HP_01_operational_description”.
1 20 2 19 3 18 4 17 5 16 6 15 7 14 8 13 9 12 10 11 RM912HP Schematic Connection Diagram and Instructions. Pin # Pin Name Pin Function Connection Instructions 1 2 G1 RF RF Ground RF Signal Via directly to ground. Route a 50 ohm trace to the antenna. 3 4 G3 SW1 RF Ground Via directly to ground.
RF Exposure Statement: This equipment has a power density well below that allowed at 23 cm; therefore, this equipment shall be installed and operated with an antenna with gain not more than 8 dBi and installed with a minimum of 23 cm of separation distance between the antenna and all persons during normal operation. FCC Regulations Statement FCC ID: UE3RM912HP This device complies with Part 15 of the FCC Rules.
RF Data rate Mechanical dimensions Selectable, see datasheet 20 x 28 mm Page 5 of 5
Banner RM912HP Transceiver 1 Watt, 900 MHz DTS User Manual Overview The Banner RM912HP device is a direct sequence spread spectrum transceiver (DSSS) operating in the 902 – 928 MHz band. It is an implementation of a particular ISM band transceiver IC that includes an external LNA in the receive path and external power amplifier in the transmit path, as well as all necessary RF switches and matching components.
each of length Tslot. During each time slot, a given radio could spend part of its time transmitting (Ton), receiving, or idle to conserve energy. To be in compliance with the rules for dwell time as tested, the radio transmitter must be on less than 50 % of the time. Power Control Users must ensure that they are maintain a conducted output power of 26 dBm or less. Contact the factory for details on adjusting RF power levels.
1 20 2 19 3 18 4 17 5 16 6 15 7 14 8 13 9 12 10 11 RM912HP Schematic Connection Diagram and Instructions. Pin # Pin Name Pin Function Connection Instructions 1 2 G1 RF RF Ground RF Signal Via directly to ground. Route a 50 ohm trace to the antenna. 3 4 G3 SW1 RF Ground Via directly to ground.
RF Exposure Statement: This equipment has a power density well below that allowed at 20 cm; therefore, this equipment shall be installed and operated with an antenna with gain not more than 8 dBi and installed with a minimum of 20 cm of separation distance between the antenna and all persons during normal operation. FCC Regulations Statement FCC ID: UE3RM912HP This device complies with Part 15 of the FCC Rules.
RF Data rate Mechanical dimensions Selectable, see datasheet 20 x 28 mm Page 5 of 5
