M535U User Guide 1. Connect the evaluation board with USB to Data & Power. 2. Follow the direction to insert the SIM card. 3. Turn on the Power Switch.
4. Launch Putty and select Serial. 5. Launch Device Manager and check the AT CMD port.
6. Input the AT CMD port to Putty. 7. Input AT command (at$qcrmcall=1,1)to establish the connection between PC and M535U. 8. How to install M535U to other host devices. Insert the module to assigned standard PCI‐E mini card slot. Secure the module using two screws and attach the cables (LTE1/2 & GPS if applicable) appropriately.
Manual Information to the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules.
End Product Labeling When the module is installed in the host device, the FCC ID label must be visible through a window on the final device or it must be visible when an access panel, door or cover is easily re‐moved. If not, a second label must be placed on the outside of the final device that contains the following text: “Contains FCC ID: UZI‐35M168” The grantee's FCC ID can be used only when all FCC compliance requirements are met.