Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. MODEL # 1906CT Patents pending, US Patent# 6,834,915 6,811,216 6,913,313 6,916,066 Shuttle Travel System Instruction Manual Convenience through Innovation and thoughtful design 01.
WARNINGS WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the seat belt and insure that the child is properly positioned according to these instructions. WARNING: Never leave child unattended.
PARTS Rear Axle Child Tray Base Locking Cap Rear Wheels Parent Tray Stroller Car Seat Seat Car Rear Wheel Housing Hub Cap Front Wheels Front Wheels Solid Cap TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. TO ASSEMBLE STROLLER * Remove stroller from box. The front wheels, rear wheels, child tray, parent tray, and canopy need to be installed prior to use.
* To attach the front child tray, push the angled tray onto the post at the end of right armrest, while pressing downward on the snap button, until locked into place. Please see figure 7. Rotate the tray downward until latched onto the left armrest. Please check that the snap button comes through and securely latches the tray in place. Please see figure 8. * To remove front child tray, press inward on the left side tray release button and rotate upward on the tray. Please see figure 9.
TO SECURE THE CHILD • The shoulder straps of the 5-point harness have 2 attachment positions. Select the position that places the shoulder strap level with, or below the top of the child's shoulder. To access the harness pull apart seat pad. Please see figure 17. • Carefully place the child in the stroller seat and bring the safety harness around the child's waist and over the shoulders. Place the crotch strap between the child's legs.
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT * To attach the Baby Trend Infant Car Seat, remove the seat back reclining strap and pass the strap through the loop on the side of the seat, repeat for the opposite side. NOTE: make sure the canopy is pushed forward then rotate each end of the straps to the inside of the canopy frame. Please see figure 19 * Check that the front child tray is firmly attached to the stroller armrests.
FRONT CHILD / CAR SEAT TRAY COVER * The cover of the child/car seat tray may be fastened in the closed position after your child outgrows the infant car seat. This will prevent an older child from opening the child tray. To secure the tray cover, remove the tray from the stroller as shown in the to remove front child tray section. Install the tray cover. Place the tray with the lid side down on a soft flat surface. Remove the screw stored under the tray as shown in figure 24.
CANOPY * To open the canopy, push forward on the front frame of the canopy. To close canopy, pull the front edge toward the rear of the stroller until folded. Always fold the canopy prior to folding the stroller frame. Please see figure 28. The canopy may be moved forward to block the sun or wind. Push forward on the front frame tube or rearward on the rear frame tube to adjust. Please see figure 29. Front frame tube Rear frame tube Figure 28. Figure 29.
CAUTION: Read the following section completely before folding your stroller! TO FOLD STROLLER * Close the canopy as described in the Canopy section above. Place seat back in fully reclined position by unbuckling recline strap. Pull stroller backward several inches to rotate the front wheels to the front. Please see figure 32. To fold the stroller slide the red fold lock with your thumb while squeezing the large red fold button in the center of the handle and push downward on the handle.
CLEANING SEAT PAD * The seat pad may be removed for washing. To remove the seat pad, unsnap the two straps on the rear of the seat as shown in figure 37. Unfasten the seat belt and pull the waist belts and crotch strap through the cutouts in the pad as shown in figure 38. Pull downward on the front edge of the seat pad to remove from the stroller as shown in figure 39. Please see the care label on the rear of the seat for washing instructions. To re-install the pad, follow these instructions in reverse order.